EMPHASER EM-MBF2 Speakers System User Manual
- June 4, 2024
- EMPHASER
Table of Contents
Speakers System
User Manual
EM-MBF2
EM-MBR2
EM-MBF2 Speakers System
Congratulations!
On your purchase of the EMPHASER audio system dedicated to Mercedes-Benz
vehicles. If you plan on installing this speaker system by yourself, please
read the following instructions carefully before you attempt the installation.
For any further information about this product, please contact your authorized
EMPHASER dealer.
SET CONTENT
Carefully remove the loudspeakers, crossovers, and accessories from the gift box and check whether all parts are in good undamaged condition, and match with the set contents listed below:
EM-MBF2
- 2 Midrange
- 2 Tweeter
- 2 2-way crossover
- 1 manual
EM-MBR2
- 2 Coaxial speakers
- 2 crossover/highpass filter
- 1 manual
ASSEMBLY
This set is compatible with a variety of Mercedes-Benz vehicles. For step-by-
step instructions on how to disassemble the original loudspeakers of your
specific vehicle correctly, please contact your Mercedes-Benz service
workshop. The following instructions for the C205 model are to serve as an
example for all models.
Loosen the two Torx 30 screws at the point marked with a circle. Using a wide
plastic wedge, carefully pry the door trim from the door panel. Start at the
point marked with an arrow and work piece by piece forward and backward. There
is a locking hook at the position marked with a rectangle. Slide the door
upwards to fully release the panel. To obtain more freedom of movement, unhook
the Bowden cable from the door lever. To do this, pull the cover out of the
guide rail and release the hook from the plastic clamp. Finally, disconnect
the necessary cables to completely remove the door trim. Use either a small
screwdriver or a paper clip to unlock the plugs.
Place the panel on a clean, soft surface. The original speaker is plugged in
at three points on the panel. If necessary, use a plastic wedge to lever out
the speaker.
EM-MBF2
Place the new EMPHASER speaker on the door panel. Push all three mounting
balls into the mounting holes one by one until they are firmly locked.
Disassemble the tweeter holder in the mirror triangle. If present, remove the
original tweeter and click on the new EMPHASER tweeter.
Run the connection cables of the supplied crossover to the tweeter (TW) and
the midrange speaker (WF). The cable labeled “IN” is to be connected to the
vehicle speaker cable that originally powered the original speaker. Mount the
door trim in reverse order.
The crossover has the option of bypassing the integrated high-pass filter if
you prefer to drive the EM-MBF2 via an amplifier with an active filter or a
DSP. To do this, simply disconnect the red and black cable at the input of the
crossover. The frequency of the high-pass filter should be set to approx. 300
Hz.
EM-MBR2
Place the new EMPHASER speaker on the door panel. Push all three mounting
balls into the mounting holes one by one until they are firmly locked.
Run the connection cables of the supplied crossover/highpass filter to the
speaker. The cable labeled “IN” is to be connected to the vehicle speaker
cable that originally powered the original speaker. Mount the door trim in
reverse order.
If you use an additional amplifier and prefer to use the integrated active
filter, the supplied crossover is not required. The frequency of the high-pass
filter should be set to approx. 300 Hz.
Assemble the door panel in reverse order.
WARRANTY CONDITIONS + LIMITATIONS
What products are covered by EMPHASER’s Limited Warranty?
The Limited Warranty (the “Warranty”) applies to EMPHASER products purchased
from an authorized dealer by end customers in the European Economic Area or
Switzerland (“Territorial Scope”).
What is the validity period of EMPHASER’s Warranty?
Under this Warranty, EMPHASER warrants, for a period of 2 years, that the
product is free from defects in material and/or workmanship at the time of the
original purchase. This 2-year period commences on the date of the original
purchase as per the original invoice or until receipt. If you have purchased
the product as a consumer, and the defect is identified within the first six
months after the original purchase (see above), we will assume that the defect
already existed at the time of purchase.
Who can claim under the Warranty?
EMPHASER grants the limited Warranty to natural persons only, who purchased
the relevant product primarily for personal use.
What is covered by the Warranty?
EMPHASER warrants that the product is free from defects in material and/or
workmanship at the time of the original purchase. EMPHASER does not, however,
provide a warranty covering every defect and damage that may occur. It only
covers the hardware components of the device and in no event the software used
with the device, regardless if this was provided by EMPHASER or the third-
party vendor. The Warranty, therefore, does not cover the following cases, in
particular:
- normal wear and tear (such as to surfaces and protective coverings);
- superficial damage, such as scratches, dents, damaged plastic, worn or mechanically defective connections;
- misuse, including any treatment resulting in physical or superficial damage, such as a cosmetic defect, to the product;
- damage caused by connecting or using the product for a purpose other than those specified, or a failure to observe the operating and/or installation instructions for the particular model;
- installation or use of the product contrary to the applicable technical standards, or the safety regulations in the country in which the product is installed or used;
- damage caused through an unauthorized attempted repair or an attempted repair by someone other than an EMPHASER authorized service partner;
- damage caused by modifications to the product not expressly authorized by the manufacturer;
- damage caused by malicious code (“Software Viruses”) or by using software not supplied with the product or which was incorrectly installed;
- use of third-party vendor software programs for editing, modifying, adapting, or extending EMPHASER’s authorized software components as are run on the product;
- use of third-party vendor firmware/operating system software
- damage caused by liquids or chemicals of whatever type, and/or excessive temperatures, moisture, or dampness;
- accidents drops, or other such effects of extreme accelerating forces;
- damage caused by lightning strikes, electrostatic charge, incorrect operating voltage, water, fire, force majeure, inadequate ventilation for other reasons for which EMPHASER is not responsible;
- damage caused by using the device outside of the defined specifications;
- damage caused by using the product with other systems or devices, which are not designed to be used with this product;
- adjustments or modifications without EMPHASER‘s prior written approval, including product upgrades extending beyond the specifications or characteristics described in the operating manual;
- modifications of the product for the purpose of adapting it to national or local technical norms or safety standards of countries for which the product was not expressly designed or manufactured;
- using service or spare parts not produced or distributed by EMPHASER;
- using the product in connection with accessories not approved for use with this product;
EMPHASER, moreover, does not warrant (expressly, implicitly, statutorily, or
otherwise) the quality, performance, reliability or suitability of the product
for a particular purpose except as described, nor the software/firmware
installed on the device ex works.
No warranty service will be provided, moreover, if the model number /serial
number/UUID/product number on the product is changed, erased, made illegible
or removed. The same applies if the receipt or invoice is incomplete and/or
illegible when presented.
Is EMPHASER liable for other defects or damage?
EMPHASER will repair or replace products, only if they are covered by the
terms of this Warranty. EMPHASER is not liable for any material or intangible
loss or damage such as the price paid for the product, loss of profits,
revenue, data, or relating to the enjoyment of the product or components
associated with it, arising directly or indirectly under this Warranty or
otherwise in relation to products or services. This likewise applies to loss
or damage relating to the impairment or operational failure of the product, or
devices associated with it, caused by defects or the non-availability of the
product during the time it is with EMPHASER or EMPHASER’s service partner, as
well as to periods of downtime and business interruptions. In addition,
EMPHASER does not accept any liability for shipment-related risks – such as
the loss or destruction of the product – in
connection with the fulfillment of the Warranty.
This disclaimer applies to losses of damage irrespective of the legal basis,
especially on the grounds of negligence, other wrongful conduct (torts),
breach of contract, express or implied guarantees, and strict liability (even
if EMPHASER or its service partner has been advised of the possibility of such
damage occurring).
If these disclaimers are prohibited or limited under the applicable law,
EMPHASER will limit its Warranty and liability to the extent permissible under
the applicable regulations. For example, some national laws prohibit the
exclusion or limiting of damages payable in connection with negligence, gross
negligence, willful wrongdoing, deceitful conduct, and other such acts. For
the duration of this Warranty, all liability that cannot be excluded
completely will be limited to the extent permissible under the applicable law.
Liability under this Warranty is limited to the price paid for the product. If
the applicable law only permits higher limits on any liability, this higher
limitation will apply.
How do I exercise my Warranty rights?
If you want to exercise your entitlements under this Warranty, please contact
the authorized dealer where the product was purchased, and present it with the
original copy of the till receipt or invoice. Do not return any products to
EMPHASER directly, otherwise, our Warranty obligations cannot be fulfilled.
You will find the name of the relevant dealer or reseller on your proof of
purchase.
Defective devices sent by the authorized dealer to the service center must
also be accompanied by any accessories with a logical connection to the
observed fault. This means, for example, the navigation package on an SD or
microSD card supplied or purchased with the device, if problems or functional
errors were observed in connection with the navigation function.
How will EMPHASER fulfill its Warranty?
EMPHASER or its service partner will choose to either repair or replace the
product or its defective parts covered by the Warranty, and assume the costs
of material and labor in doing so.
Repairs under the Warranty must be carried out by EMPHASER or its authorized
service partner. Products that are repaired or replaced may contain new and/or
refurbished components and devices. Components that are swapped out will
become the property of EMPHASER.
Will I incur any costs in connection with the Warranty service?
EMPHASER assumes the costs of material and labor in connection with its
Warranty service. The Warranty holder is responsible for the costs of shipment
and bears the risks connected with the shipment (see above). If the product is
found to be operating faultlessly, or there is no warranty entitlement because
the warranty period has expired or for any other reason, EMPHASER or its
authorized service partner will be entitled to charge a flat-rate
investigation fee of €30.00.
Does this Warranty affect my statutory or contractual rights?
This Warranty is made voluntarily by EMPHASER, and it will, in any case,
extend your statutory rights. As a consumer, you remain fully entitled to your
statutory rights, such as the statutory guarantee. This Warranty also has no
effect whatsoever on your contractual rights against the reseller.
You may continue to exercise these rights in full.
WARRANTY SLIP / GARANTIEKARTE
MODEL: ❏ EM-MBF2 ❏ EM-MBR2
Date of purchase:
Your name:………..
Your address:……………
City:………….
State: ZIP or Postal Code:………….
Country:…………
Your phone number:………
Installation Approval
❏ Installed by an authorized dealer
❏ Self-installed by customer
Installation date:……….
Inspected and approved by:………
www.emphaser.com
Manufacturer:
ACR, Brändli + Vögeli AG, Bohrturmweg 1, CH-5330 Bad Zurzach, Switzerland
Phone: (+41) (0)56 269 64 64, Fax: (+41) (0)56 269 64
65,mail@acr.eu, www.acr.eu
EU Legal Representative:
ACR S & V GmbH, Industriestraße 35, D-79787 Lauchringen, Germany
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>