BRAYER BR2105 Toaster Instruction Manual
- June 15, 2024
- BRAYER
Table of Contents
BR2105 Toaster
Instruction Manual
BR2105 Toaster
Toaster BR2105
Тостер BR2105
A toaster is a household appliance intended for quick toasting of thin slices of bread (toasts).
DESCRIPTION’
- Slots for bread toasting
- Carriage control lever
- Toasting level control knob «1-2-3-4-5-6-7»
- Toasting stop button «CANCEL»
- Reheating mode button «REHEAT»
- Defrosting mode button «DEFROST»
- Power cord storage
- Crumb tray
ATTENTION!
For additional protection it is reasonable to install a residual current
device (RCD) with nominal operation current not exceeding 30 mA, to install
RCD, contact a specialist.
SAFETY MEASURES AND OPERATION RECOMMENDATIONS
Read the operation manual carefully before using the toaster maker; after
reading, keep it for future reference.
-
Use the unit for its intended purpose only, as it is stated in this manual.
-
Mishandling the unit can lead to its breakage and cause harm to the user or damage to the user’s property, which is not covered by warranty.
-
Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
-
Connect the power plug to the socket with reliable grounding contact. In case of short circuit the grounding reduces the risk of electric shock.
-
Contact an electrical technician, if you are not sure that your power outlets are installed properly and grounded.
-
Do not connect the unit to external timers or remote control mains sockets.
-
To avoid fire, do not use adapters for plugging the w in.
-
Install and use the unit on a flat, dry, steady and heat-resistant surface with free access to the mains socket.
-
Use the unit in a well-ventilated room, for normal air circulation the free space around the toaster maker should be at least 10-15 cm on each side.
-
During the toaster maker operation do not allow the unit body to come in contact with curtains, wall coverings, clothing, kitchen towels or other flammable materials.
-
Do not use the unit outdoors.
-
It is recommended not to use the unit during lightning storms.
-
Protect the toaster maker from impacts, falling, vibrations and other mechanical stress.
-
Never leave the unit connected to the mains unattended.
-
Do not cover the toaster with any foreign objects during its operation.
-
Do not use the unit near heating appliances, heat sources or open flame.
-
Do not use the toaster maker in places where aerosols are used or sprayed, and in proximity to inflammable liquids.
-
Do not use the toaster maker in proximity to the kitchen sink, in bathrooms, near swimming pools or other containers filled with water.
-
If the toaster maker is dropped into water, unplug it immediately, and only then you can take the unit out of water. Apply to the service center for testing or repairing the unit.
-
Do not let the power cord touch hot surfaces and sharp edges of furniture.
-
Do not move the toaster maker when it is hot; wait until it cools down completely.
-
It is not recommended to turn on the device if there are no slices of bread in the toaster.
-
To avoid risk of fire, do not put oversized food into the toaster, do not wrap the food in food-grade foil.
-
Do not remove the toasts during the unit operation.
ATTENTION! Select and set the required toasting level correctly, the bread can catch fire if you toast it too long. -
Do not use the toaster for toasting pastries with too much sugar or filled with jam or marmalade.
-
The metal parts heat up strongly during the toaster operation, be careful and do not touch its hot surfaces.
-
Unplug the unit after usage or before cleaning. When unplugging the toaster maker, hold the power plug and carefully remove it from the mains socket, do not pull the power cord, as this can lead to its damage and cause a short circuit.
-
Do not touch the unit body, the power cord and the power plug with wet hands.
-
For child safety reasons do not leave polyethylene bags used as packaging unattended.
ATTENTION! Do not allow children to play with polyethylene bags or packaging film. Danger of suffocation! -
The unit is not intended for usage by children.
-
Do not leave children unattended to prevent using the unit as a toy.
-
Do not allow children to touch the unit body, the power cord or the power cord plug during operation of the unit.
-
Be especially careful if children or disabled persons are near the operating unit.
-
During the unit operation and breaks between operation cycles, place the unit out of reach of children.
-
The device is not intended to be used by physically, sensory, psychologically or mentally handicapped people (including children), or when they lack experience or knowledge if they are not under supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the device.
-
From time to time check the power cord integrity.
-
If the power cord is damaged, it should be replaced by the manufacturer, a maintenance service or similar qualified personnel to avoid danger.
-
Do not repair the unit by yourself. Do not disassemble the unit by yourself, if any malfunction is detected, and after the unit was dropped, unplug it and apply to the authorized service center.
-
To avoid damages, transport the unit in the original package.
-
Keep the unit in a dry cool place out of reach of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, DO NOT USE THE UNIT FOR COMMERCIAL OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After unit transportation or storage at negative temperature, unpack it and wait for 3 hours before using.
-
Unpack the unit and remove all the packaging materials.
-
Keep the original package.
-
Read the safety measures and operating recommendations.
-
Check the delivery set.
-
Examine the unit for damages, in case of damage do not plug it into the mains.
-
Make sure that the indicated specifications of the power supply voltage of the unit correspond to the specifications of your mains. When the unit is used in the mains with 60 Hz frequency, no additional actions are required.
-
Clean the unit body surface with a soft, slightly damp cloth, and then wipe it dry.
-
On the bottom part of the toaster body there is a cord storage (7). Select optimal length of the power cord laying it in a corresponding way.
-
Connect the power plug to the mains socket and set the toasting level control knob (3) to the position «7». Switch the unit on by pressing on the carriage control lever (2), the lever (2) will be fixed in the lower position, and the toasting stop button (4) «CANCEL» illumination will light up.
Note: the toaster switch-on lever (2) will be fixed only if the power cord is plugged into the power outlet. -
At the end of the set time the toaster will automatically switch off and the lever (2) will return to the initial position.
-
During the first switching on the heating elements burn, therefore occurrence of a small amount of smoke or foreign smell is possible. It is normal and is not a warranty case.
-
If necessary, switch the toaster on for several times.
MAKING TOASTS
ATTENTION!
– Never try to take jammed toasts out of the operating toaster with your hands
or with metal objects, as contact of the metal object with the heating element
under voltage may cause electric shock.
– Unplug the unit and wait until the toaster cools down. After that you can
take the jammed toasts out with a suitable wooden or plastic spatula.
– To avoid getting burns, do not touch metal parts of the toaster with your
hands or open parts of your body during toaster operation.
- Make sure that the crumb tray (8) is installed.
- Put two slices of bread into the slots for bread toasting (1).
- Insert the power cord plug into the power outlet.
- Set the toasting level of the toasts by turning the control knob (3):
«1» – minimal toasting level;
«7» – maximal toasting level.
Notes:
– the toasting level depends on the sort of bread and thickness of slices.
Optimal thickness of the slices should not exceed 20-25 mm;
– select the toasting level by setting the control knob (4) to the needed
position.
– do not use very thin slices of bread, because they do not center in the
toaster.
– to obtain a uniform color of the ready toasts, it is recommended to make at
least 30 seconds pause between each toasting.
- Press on the carriage control lever (2) until fixed, the toasting stop button (4) «CANCEL» illumination will light up.
- When the toasts are ready, the toaster will be switched off automatically, the lever (2) will return to its initial position.
- You can slightly lift the lever (2) to take out the ready toasts.
TOASTING STOP BUTTON (4) «CANCEL»
- If you need to switch the toaster off or stop the toasting process, press the toast making stop button (4) «CANCEL».
- The toaster will be switched off, and the lever (2) will return to the initial position.
REHEATING MODE BUTTON (5) «REHEAT»
- To reheat the cooled toasts, lower the toasts into the holes (1), press the toaster actuating lever (2) until it locks, then press the «reheat» button (5) «REHEAT» while the illumination of the button (5) «REHEAT» will light up.
- When the toasts are heated, the toaster will be switched off automatically, the lever (2) will return to its initial position.
DEFROSTING MODE BUTTON (6) «DEFROST»
- To toast frozen bread, put the slices in to the slots for bread toasting (1). Set the required toasting level with the control knob (4), press the carriage control lever (2) until it latches and then press the button (6) «DEFROST»; the DEFROST mode button (6) «DEFROST» and the toasting stop button (3) «CANCEL» illumination will light up. • When the toasts are ready, the toaster will be switched off automatically, the lever (2) will return to its initial position.
CRUMB TRAY
- Bread crumbs are accumulated in the tray (8), regularly clean the tray (8).
- Switch the toaster off and unplug the power cord plug from the mains socket, wait until the toaster cools down.
- Remove the crumb tray (8), clean it off the crumbs and install the tray back to its place.
CLEANING AND CARE
- Before cleaning, unplug the power cord from the power outlet, let the device cool down.
- Wipe the toaster maker body with a slightly damp cloth, and then wipe it dry.
- Do not use metal washcloths, abrasive cleaning agents or solvents to clean the toaster.
- From time to time remove and clean the crumb tray (8).
Attention!
To avoid electric shock do not immerse the toaster maker, the power cord or
the plug into water or other liquids.
STORAGE
- Clean the toaster maker before taking it away for long storage.
- Put the power cord into the cord storage (7).
- Keep the unit in a dry cool place out of reach of children and disabled persons.
DELIVERY SET
- Waffle maker: 1 pc.
- Instruction: 1 pc.
TECHNICAL SPECIFICATIONS
- Power supply: 220-240 V, ~ 50/60 Hz
- Rated input power: 870 W
RECYCLING
To prevent possible damage to the environment or harm to the health of people
by uncontrolled waste disposal, after expiration of the service life of the
unit or the batteries (if included), do not discard them with usual household
waste, take the unit and the batteries to specialized stations for further
recycling.
The waste generated during the disposal of products is subject to mandatory
collection and consequent disposal in the prescribed manner.
For further information about recycling of this product apply to a local
municipal administration, a household waste disposal service or to the shop
where you purchased this product.
The manufacturer reserves the right to change the design, structure and
specifications not affecting general operation principles of the unit, without
prior notice.
The unit operating life is 3 years
The manufacturing date is specified in the serial number.
In case of any malfunctions, it is necessary to apply promptly to the
authorized service center.
brayer.ru
Produced for «Rusted GmbH»,
Bagasse 18/18, 1090 Vienna, Austria
т.: +7 (495) 297-50-20,
e-mail: [email protected]
Made in China