Miiiw MW23W11 Bluetooth Earphone User Manual
- June 15, 2024
- MIIIW
Table of Contents
Miiiw MW23W11 Bluetooth Earphone
Know your earbuds
Charging
- Charging time: About 1.5 hours for earbuds, about 1.5 hours for charging case
- Talk time: Approximately 5 hours
- Music playback time: Approximately 6 hours
- Charging case：380mAh
- Battery capacity: (Earbud) 40mAh x 2
- Fully charged case: 2~3 times of charging for earbuds
- Bluetooth version: 5.3
Indicator status
- Charging case “charging”: White light ashes
- “Fully charged”: White light keeps on
- Earbuds “charging”: Only place the earbud into the charging case, close the cover, and the indicator ashes once.
- Place the two earbuds in the charging case at the same time and close the cover, the indicator ashes twice, then keeps on and charges the earbuds.
- “Fully charged”: The indicator goes out and enters standby mode.
Bluetooth pairing
Open the charging case, the right earbuds automatically turn on to pair, and the earbuds indicator ashes alternately in white and blue. Open the Bluetooth of the device, search for “MIIIW-W11” and click. hearing the “Connected” prompt tone, you can use them.
Notes
- If the connection fails, place the earbuds in the charging case and repeat the above steps.
- The earbuds only support one-on-one pairing and cannot be paired with two devices at the same time. If you want to use them on other devices, please disconnect the paired device to connect to the new one.
- If you need to replace the device, press and hold the earbud reset button on the charging case for 5 seconds to disconnect the paired device.
Instructions
Names and content of hazardous substances in the product
- Judge according to provisions of EU RoHS 2.0 Amendment Directive(EU) 2015/863.
- O: Indicate the content of hazardous substances in all homogeneous materials of the part is below the limit requirement.
- X: Indicate the content of the hazardous substance in all homogeneous materials of the part is above the limit requirement.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>