sauermann Si-CA 8500 Industrial Combustion Analyzer Instruction Manual
- June 15, 2024
- sauermann
Table of Contents
sauermann Si-CA 8500 Industrial Combustion Analyzer
Product Information
The Si-CA 8500 is an analyzer device designed for measuring various parameters including temperature, CO, CO2, HC, NO2, SO2, DFT, and H2S. It features a sample conditioning unit (SCU) for gas treatment and a built-in pump for air sampling. The device has a digital display for easy reading of measurements and comes with options for data storage and printing.
Specifications
- Measurement Units: CFM, CMM, FPS, MPS, #/H, T/D, PPM, MGM, GBH, #/B, WC, mmWC, kPa, mbar, %, in2, cm2
- Temperature Units: F
- Battery: x.xx V
- Version: 1.00
- Baudrate: 9.6 kbps
Product Usage Instructions
Unpacking the Device
To unpack the Si-CA 8500, follow these steps:
- Open the packaging box.
- Remove the device from the box.
Startup Instructions
To start up the Si-CA 8500, follow these steps:
- Connect the device to a power source.
- Press the power button to turn on the device.
- The pump of the analyzer will start immediately and the Sauermann logo will appear on the display.
- Press the “OK” button to perform autocero.
Safety Guidelines
For the safety of the user and proper operation of the device, please follow these guidelines:
- Ensure the device is placed on a stable surface.
- Avoid exposing the device to extreme temperatures or humidity.
- Do not touch any hot surfaces of the device.
- Keep the device away from water or any liquids.
FAQ
Q: What should I do if the analyzer does not turn on?
A: If the analyzer does not turn on, please check the power connection.
Make sure the charger is connected properly and there is no excessive heat in
the device casing. If the issue persists, try resetting the analyzer and check
if there is any blockage in the exhaust gases at the bottom of the device.
Q: How do I perform autocero for all sensors?
A: To perform autocero for all sensors, press the “OK” button and select
the “Zero All Sensors” option. This will initiate autocero for all the sensors
in the device.
Q: Can I print test records with the Si-CA 8500?
A: Yes, you can print test records with the Si-CA 8500. Press the “OK”
button and select the “Print Test Record” option to print the test record on
the remote printer of the device.
Q: How should I store the device after measurements?
A: After completing measurements, remove the probe from the duct and let
the analyzer aspirate clean ambient air for a few minutes. Allow the probe to
cool down before storing it in the provided carrying bag.
References
- Manufacturer of Condensate Pumps and Measuring Instruments | Sauermann group
- Instrumentos de medición | Soluciones de gestión de condensados | Sauermann group