Bamboosang 21V High Pressure Washer and Cordless Portable Cleaner Instructions
- June 15, 2024
- Bamboosang
Table of Contents
Handheld lithium electric cleaner
Product instructions
Car washing machine manual
Product safety operating standara is applicable to ourseries of products
User security warning!
When using this product, you must read the safety specification manual and
related warnings and safety precautions carefully! Failure to follow the
following warnings and instructions can result in electric shock, fire or
personal injury!
Be sure to save the warning instructions as reference for unfamiliar
operators!
Safety Warning for Handheld Lithium Battery Cleaner!!
- when using the machine,make sure itis the original machine and accessories (charger and battery pack)
- when using, do not shoot water directly at people.
- Ensure that children are not exposed to the range area when the battery pack is charged.
- Immediately stop using battery packs and chargers when they are dropped, bumped, or exposed to moisture!
- Someone must be present when charging the battery pack.
- Chargers must comes from the original factory (It is forbidden to use other charging accessories or charging methods without authorization or as recommended by the original factory.)
- Charging environment is prohibited in high temperature or unattended or accessible for children.
- regularly carry out product inspections of chargers, battery packs, car washing machine mainframes. If there is any abnormality or damage or failure, please do not modify or disassemble without permission
Warning
Reading Instructions
Batteries contain lithium,in order to protect the environment,waste batteries
should be classified recycling,not random littering!
Don’t putinto the water or the fire source (or near the fire source)
Safety precautions for battery pack
- Do not disassemble,open or shred battery sets.
- lt is forbidden to expose battery pack to heat source or high temperature sunlight.
- Do not short circuit the battery pack (positive and negative poles are wrongly connect-ed),do not put the battery pack in the box or drawer, it can avoid short circuit between them or by other metal items.
- Do not remove the battery or battery pack from the original package before use
- Prohibit battery packs from falling or mechanical impact
- 0nce the battery leaks,do not touch the leaking liquid directly. In case of accidental contact with eyes or skin, rinse the contact area immediately with plenty of water and consult a doctor in time.
- Shall not use non-original charger and battery pack. (It could causes machine malfunction or accidental personal injury)
- Pay attention to the positive and negative signs on the battery pack to ensure proper connection.
- Keep the machine and battery pack group away from children.
- If the purchase of a matching battery pack or charger must be directed by the manufac-turer
- Ensure battery pack are clean and dry. (If there i dust or residual water, it should be immediately wiped with clean cloth or natural air drying,do not use hair dryer or hot air gun drying)
- The battery pack must be charged before use,using the correct charger and referring to the manufacturer’s operating instructions or the original equipment instructions
- When the machine is not in use, do not charge the battery pack for a long time, pay attention to the lights. Green light is full of electricity,and red light is in charge.
- If the machine has not been used for a long time, the battery packs should be subjected to several charge/discharge cycles to achieve optimal performance.
- Using of battery pack groups at room temperature (20°C+5’C) performs best.
- This product is only suitable for home doors and windows,courtyard,vehicles,garden cleaning operations,can not be used for commercial operations or main frequency flow operations. Must not exceed the battery pack’s use time or high-frequency compulsory use
- Remove the battery pack when the machine is not in use disconnect from the mainframe and place it in a dry place out of the reach of children.
- Damaged battery packs should be properly handled and recycled, and should not be discarded at will to pollute the environment
Product Description
The lithium battery wireless hand-held cleaning machine is developed, designed
and manufactured by the professional support team. The original intention of
product develop-ment: in line with the principle of giving priority to user
experience and quality, the pursuit of convenience, speed, portability and
energy saving. Itis a product tailored for the majority of car lovers and home
cleaning and washing. At the same time the product is not limited by power
supply,with strong and stable battery.Product can be carried with you, and can
be used in multiple scenarios, saving time and your cleaning costs, brings DIY
washing fun and quality experience.
Product parameters are configured according to user selection.
Accessories options:
- Suggestions for insufficient battery life or need for enhancement ~1 battery packs
- Multi-angle Cleaning – 3 in 1 nozzle is recommended
Installation process and user requirestions
Open the box to check whether the machine is in good condition and whether it
is the corresponding model for purchase.Then take the parts out one by one and
place it on a flat surface. Install and use according to the operation
procedure!
Machine type:
21V lithium battery model
| Step 1: Insert the battery pack correctly into the machine as shown. (takes
about 4 hours to charge, do not overcharge).
---|---
| Step 2: Correctly insert the nozzle into the machine and rotate it firmly.
(Insert firmly in both directions and rotate to secure)
| Step 3: Insert the water inlet connector into the machine and snap it
firmly. (The joint contains a sealing ring, check whether it is in good
condition. If it is not installed in place, it will cause the machine to not
absorb water, idle, and create no pressure)
Step 4: After the installation, put the water inlet pipe (the end with the
filter screen) into the water source.
It must be completely immersed in the water and cannot float on the water
surface. Otherwise, air will enter during operation and the machine cannot be
used normally.
| Step 5: how to install the foam pot: insert the foam pot into the barrel and
rotate it firmly.
(et firmiy in both directions and rotate o secure) tep 6: After
cleaning,remove battery pack and other accessories in a cool and dry place.(Do
not store in the trunk of the car or other high temperature environment in hot
weather)
---|---
| Step 7: Open the plastic cover and insert the plug to charge
Operational considerations
Hold the trigger 10s-15s empty the air in the intake pipe (if no water go out,
check whether the inlet is connected or the intake pipe is immersed in the
water)
The moment when the machine starts, the motor sparks. That’s the light due to
the friction of the motor’s carbon brushes. This is normal. No need to worry.
The above are the precautions for the installation and operation of car
washing machines.
If you do not understand or have other questions, you can contact the after-
sales customer service. You will get operation videos and considerate
services.
How to clean the vehicle quickly
First use a fan nozzle (top-down spraying) to wash off the dust on the car.
Then use a high pressure straight nozzle to flush the dirty parts such as
thick soil. Afterwards use a foam pot to spray the foam on the car. Then scrub
the car with a car wash sponge and finally, rinse the car with the high
pressure washer. It usually takes 10-20 minutes, 25-40 liters of water (2-3
barrels of water).If you need to strengthen battery life, you can choose high
configuration high-continuum version car washing machine.
Troubleshooting
Frequently Asked Questions | Cause analysis | Solutions |
---|---|---|
The machine runs normally and does not absorb water | 1.machine is too high | |
above water | Lower the machine to less |
than 1,5m from the ground
2.The Filter is clogged| Remove and clean filter
3.The connection between the water inlet pipe and the machine is not good, the
air leaks, or the water inlet pipe is broken| Check and replace water
pipes,please contact customer service
4.intake pipe is bent| Straighten out intake pipes and reconnect
5.the pump froze because of the cold weather| Restart after thawing
Sudden increase in effluent pressure or abnormal water type| The nozzle of the
water gun was blocked| Use a needle to clear the nozzle or replace the
new gun nozzle
Machine does not start| 1.battery pack not installed| Re-install
2.battery pack is out of battery| Charge or replace new battery pack
3.battery pack is broken| Replace the battery pack
Battery pack can’t be charged| Charger mismatched or broken| Replace to a
correct charger
Machine pressure discontinuity| 1.Air in pump| Check that joints and pipes are
in good condition
2.machine in low voltage mode| Normal at low pressure, no treatment required
Machine automatic stop| 1.battery pack is out of battery| Charge or replace
battery pack
2.the nozzle blocked,current protection| To clear or replace the nozzle
Leakage inside machine| Chemical acid source or assembly cause| Avoid using
chemical sources
Repair and maintenance
- Please check if the machine and parts are damaged every time before using, if it is damaged, please stop using the machine and contact the supplier or manufacturer to replace the parts.
- intake pipes and filters must be cleaned after using and cover them with bags to avoid oxidation for easy use in the future.
- After use, it should run for a few seconds without connecting the water inlet. Drain the residual water in the machine, avoid oxidative dirt and freezing due to weather,,and store in adry cool place.
- waste disposal: damaged accessories and packaging materials must be sorted and recycled, and relevant signs must be made.
- Do not store in the trunk of the car in high temperature weather so as to avoid fire caused by high temperature.
Warning: do not use chemical acid and muddy water,please use clean ,impurity-free clear water.