BASELINE RM2200 Hydraulic Wrist Dynamometer Instruction Manual
- June 3, 2024
- BASELINE
Table of Contents
BASELINE RM2200 Hydraulic Wrist Dynamometer Instruction Manual
Package Content
About the Baseline® Wrist Dynamo meter
- Simply and accurately measures the strength of the wrist muscles during flexion, extension, abduction and adduction and the forearm muscles during supination and pronation.
- The Baseline® wrist/forearm dynamo meter features the time proven hydraulic system used in the industry accepted Baseline® and Jamar® hand dynamometers.
- For hand held use, the dynamo meter can accommodate the Baseline® single-grip and dual-grip handle.
- Maximum reading remains until the unit is reset.
- The strength reading can be viewed as pounds or kilograms.
- Comes with portable carrying case.
- Made in USA with a 1-year manufacturers warrantee.
- CE certified.
Baseline® wrist/forearm dynamometer
Includes door knob grip and case.
12-0250 analog (dial) readout
12-0251 digital (LCD) readout
Measurement accessories
Measurement accessories easily snap on and off.
- 12-0261 [d] door knob grip [supination / pronation]
- 12-0262 [a] shovel handle [supination / pronation]
- 12-0263 [c] lever handle [abduction / adduction]
- 12-0264 [b] rod/pipe grip [flexion / extension]
- 12-0385 [e] single grip handle
- 12-0389 [f] dual grip handle
- 12-0266 table-mount bracket
USAGE
Snap appropriate grip into the wrist dynamo meter body to secure unit for test. hold unit either by grasping the dynamometer body, or using a single or dual grip handle. Set max indicator to zero. Have patient twist grip with maximum force, note reading. Re-set to zero for next test.
CALIBRATION
The BASELINE® wrist dynamo meter is a sealed unit and calibrated at the factory. However, if indicator needle is out of “zero-range” it may be reset. Remove clear cover by turning counter clockwise. Adjustment pin located by 220Kg marking. Turn pin to reset to zero. If unit is leaking hydraulic fluid it should be returned to factory for repair and re calibration.
HOW TO INSTALL HANDLES
Single Grip Handle:
- Remove screws “D” and “J”
- Position single grip handle and apply 2 thumb screws to connect the handle to the openings at “D” and “H”
Dual Grip Handle:
- Remove screws “A” “D” E” and “H”
- Position dual grip handle and apply 4 thumb screws to connect the handle to the
WARRANTY
The BASELINE® Hydraulic Wrist Dynamo meter is warranted for 1 (one) full year (parts and labor) from date of purchase. If unit needs repair contact your local dealer or Fabrication Enterprises, Inc.
Fabrication Enterprises, Inc.
3 Westchester Plaza STE 111
Elmsford, NY 10523
U.S.A.
TEL: 800-431-2830,
914-345-9300
FAX: 914-345-9800
More info: www.BaselineProducts.net