SQUARE D SQR421011 Tamper Resistant Heavy Duty Sin Instruction Manual
- June 15, 2024
- SQUARE D
Table of Contents
D SQR421011 Tamper Resistant Heavy Duty Sin
Instruction Manual
SQR421011 Tamper Resistant Heavy Duty Sin
Instruction Bulletin
GDE77974
Rev. 01, 08/2022
Replaces
Weather and Tamper Resistant (WR/TR) Outlets
Retain for future use.
Table
| SQR42101**1 | TR duplex outlet, resin, self-ground, PI/side wire, 15 A, 125 Vac |
|---|---|
| SQR42104** | WR/TR duplex outlet, resin, self-ground, PI/side wire, 15 A, 125 |
Vac
SQR42201| TR duplex outlet, comma, self-ground, back/side wire, 20 A, 125
Vac
SQR42204| WR/TR duplex outlet, comma, self-ground, back/side wire, 20 A, 125
Vac
SQR42100**| TR single outlet, comma, self-ground, side wire, 15 A, 125 Vac
1 ** = color code: WH (white/Blanco/blanc)
Table : Specifications
| Voltage | 125 Vac |
|---|---|
| Maximum load rating | 15 A / 20 A |
| Supply connection | Copper wire |
| Operating temperature | 23–113°F (-5–45°C) |
1 #12–14 AWG for screw terminal, #14 AWG for push-in terminal
Precautions
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
- Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E, NOM-029-STPS-2011 or CSA Z462 or local equivalent.
- This equipment must only be installed and serviced by qualified electrical personnel.
- Turn off all power supplying this equipment before working on or inside equipment.
- Always use a properly rated voltage sensing device to confirm power is off.
- Use with copper wire only.
- Indoor use only for TR receptacle.
- Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
WARNING: This product can expose you to chemicals including Carbon black which is known to the State of California to cause cancer, and Bisphenol A (BPA), which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Installation
-
Turn off all power. Use a properly-rated voltage sensing device to confirm power is off.
-
Wire the device according to Figure 1, using appropriate wiring methods.
A. Push-in: Accept only #14 AWG solid copper wire. Insert straight #14 AWG solid copper with strip length of 0.5 in. (12.7 mm) into round push-in holes. For circuits with #12 AWG copper wires, use terminal screws instead. Compatible with SQR42101 and SQR42104.
NOTE: Push-in terminals are not for reuse.
B. Back wire: Insert straight #12–14 AWG solid copper wire with strip length of 0.5 inch (12.7 mm) into clamp of appropriate terminal.
C. Side wire: Connect #12–14 AWG solid copper wire with strip length of 0.625 inch (15.875 mm). Loop clockwise 2/3 of the way around the screw.
Figure 1: Wiring Diagrams
**** Wire Connections
Back wire/Push-in Side wire Clockwise, 2/3 of the way around screw -
Mount the device by tightening the screws.
-
Install the wall plate (not included) on the device matching “top” marking with “top.” See Figure 2.
-
Restore power.
Figure 2 : Wall Plates
Warranty Information
Schneider Electric warranties this product to be free of defects in materials
and workmanship for a period of two (2) years. There are no obligations or
liabilities on the part of Schneider Electric for consequential damages
arising out of or in connection with the use or performance of this product
or other indirect damages with respect to loss of property, revenue or profit,
or cost of removal, installation or re-installation.
Electrical equipment should be installed, operated, serviced, and maintained
only by qualified personnel. No responsibility is assumed by Schneider
Electric for any consequences arising out of the use of this material.
Schneider Electric and Square D are trademarks and the property of Schneider
Electric SE, its subsidiaries, and affiliated companies. All other trademarks
are the property of their respective owners.
Schneider Electric USA, Inc.
800 Federal Street
Andover, MA 01810 USA
888-778-2733
www.se.com/us
© 2020–2022 Schneider Electric
All Rights Reserved
References
- P65Warnings.ca.gov
- p65warnings.ca.gov/
- Schneider Electric Canada | Global Specialist in Energy Management and Automation
- Schneider Electric Mexico | Servicios de Renovación y Retrofit de Schneider Electric
- Schneider Electric USA | Global Specialist in Energy Management and Automation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>