Achim Home Decor Tivoli Self Adhesive Vinyl Floor Tiles Installation Guide

Table of Contents

Achim-Home-Decor-Tivoli-Self-Adhesive-Vinyl-Floor-Tiles-
PRODUCT

IMPORTANT: Make sure the PATTERN number located on the side of this box is the same when using two or more boxes.
Before installing the tiles, store them at room temperature for at least a day.

All men: Hirina macks and holes With such e a level. filler and coat all areas with a suitable latex sealer. Not to be installed on untreated cement.
Wood: Make sure all planks or plywood are securely nailed down.Counter-sink nail heads, and cover with latex filler.
The surface must be completely clean and free of paint, varnish, or wax, and completely seal all areas with a suitable latex sealer.
Resilient Vinyl: Remove all dirt, grease, or wax buildup.
Do NOT install tiles over cushioned vinyl rubber flooring. Remove flooring or cover with plywood.
If installing plywood, remember to countersink the nails cover the holes with filler, and then completely seal with a suitable latex sealer.

DO NOT INSTALL TILES OVER:

To Begin:

You must determine the center point of your room. Measure the center points of opposite walls and secure a chalk line from one to the other. Snap the line. Repeat the process with the other set of opposite walls.
The point at which the chalk lines intersect is the room’s center. (Figure 1)

Wherever tiles are marked with arrows in the back, install them so that all arrows point in the same direction. Starting at the center point as shown in Figure 1. peel off the protective paper and carefully align the tile with the chalk line markings.
Press down firmly. (Caution: the tile’s protective paper covering is very slippery. To avoid accidents, do not leave the paper on the floor after you’ve peeled it from the tile.)
Moving along the chalk line, but each tile squarely and as tightly as possible. Without going directly against the wall initially, form an “L” shape as shown in Figure 2.
Cover a quarter of the surface area at a time. Do not install tiles to the edges of the room until the main floor area has been covered.

How Many Do You Need

Tiles should be cut with a straight edge and utility knife. (Do not cut over newly installed tiles as the blade may damage the new tiles.) Cut edges should face the wall. If possible, slide cut edges under wall molding.
To fit tiles around irregularly shaped objects, make a pattern of the exposed area with a sheet of paper. Use the paper cut-out as a template.
Placing the paper cut-out on the front side of the tile, trace the contours of the paper onto the tile. Cut around the marked contours.

While Tivoli Tile floors require minimum maintenance, please follow these guidelines:
Sweep, damp mop, or vacuum regularly.
Avoid abrasive cleansers.
Use furniture leg coasters.
Occasionally use an appropriate vinyl tile cleaner.
DO NOT WAX. This will make the floor’s surface too slippery and may cause accidents.