ALPINE HEARING PROTECTION 352-2 Work Safe Ear Plugs Instruction Manual

June 15, 2024
ALPINE HEARING PROTECTION

ALPINE HEARING PROTECTION 352-2 Work Safe Ear Plugs

Product Information

Specifications

  • Product Name: Soap Savon Seife
  • Attenuation Data: Tested according to EN 352-2: 2020
  • Frequencies (Hz): 63, 125, 250, 500, 1000, 2000, 4000, 8000
  • Mean Attenuation (dB): 23.4, 23.1, 23.6, 22.3, 23.4, 27.2, 26.3, 25.1
  • Standard Deviation (dB): 5.1, 5.0, 4.1, 3.9, 3.3, 3.7, 4.0, 3.9
  • Assumed Protection in dB (APV): 18.3, 18.1, 19.5, 18.4, 20.1, 23.5, 22.3, 21.2

Product Usage Instructions

Step 1: Insertion

  1. Ensure your hands are clean and dry.
  2. Gently roll the Soap Savon Seife earplugs between your thumb and fingers to compress them.
  3. Insert the compressed earplug into your ear canal.
  4. Hold the earplug in place for a few seconds while it expands and creates a seal.

Step 2: Adjustments

If the earplugs feel uncomfortable or do not fit properly, you can make the following adjustments:

  • Gently remove the earplugs from your ears.
  • Re-roll the earplugs and insert them again, ensuring a snug fit.
  • If necessary, trim the stem of the earplug for a better fit.

Step 3: Removal

  1. Gently twist and pull the earplug to remove it from your ear canal.
  2. Store the earplugs in a clean and dry container for future use.

FAQ

Q: What is the Noise Reduction Rating (NRR) of Soap Savon Seife?

A: The Noise Reduction Rating shows the range of protection expected from this protector in normal usage. The lower number represents the amount of protection possible for most users (80%) to achieve or exceed. The higher number represents the amount possible for a few motivated proficient users (20%) to achieve or exceed. Higher numbers denote greater protection.

Q: Where can I find more information about Alpine Hearing Protection?

A: You can visit the Alpine Hearing Protection website at www.alpine.eu for more information about their products and documentation.

HOW TO USE

ALPINE-HEARING-PROTECTION-352-2-Work-Safe-Ear-Plugs-
FIG-1

ATTENUATION DATA Alpine WorkSafe Tested according to EN 352-2: 2020

Variability of Noise Reduction as a Function of Noise Spectra.

Spectral Balance B = LC-LA (dB)

PRODUCT INSTRUCTION

  • The hearing protector is intended to protect the wearer from hazardous noise levels. The wearer should ensure that the earplugs are fitted, adjusted and maintained in accordance with this Instruction Manual.
  • Any other uses are not intended and therefore not allowed. Always wear the earplugs when in a noisy environment, without interruption. Slightly pull up your ear and with your other hand insert the earplug into the ear, until the protector fits snugly. Do not place the earplug too deep in the ear. Improper fit, improper use or failure to follow the instructions of this device will decrease noise reduction effectiveness, increase the risk of hearing damage and affect the lifespan of the reusable earplugs. Alpine Hearing Protection is not liable for any damage arising from misuse. Check the working order of the earplugs regularly and store them in the original, clean packaging. Clean the earplugs regularly with mild soap and lukewarm water. Dry off after cleaning. The reusable earplugs can be used approximately 100 times. Sudden or rapid removal of hearing protection may cause damage to the eardrum.
  • Do not remove plugs from the ear by pulling the connecting cord. Do not use a connecting cord if there is a chance of getting entangled. When this device is worn as directed, the level of noise entering a person’s ear is approximated by the differences between the A-weighted environmental noise level and the lesser and greater NRRs. Caution: For predominantly low frequency noise environments in which the difference in the measured C-weighted and A-weighted noise levels (dBCdBA) exceeds 3 dB, the user is directed to the enclosed graph of the variability of noise reduction with noise spectra to determine the level of protection. This product may be adversely affected by certain chemical substances. Further information should be sought from the manufacturer. Hereby, Alpine Hearing Protection, declares that the hearing protector WorkSafe is in compliance with the PPE regulation (EU) 2016/425. The full text of the EU Declaration of Conformity is available at the following internet address: www.alpine.eu/doc

Alpine Hearing Protection
Amersfoortsestraat 70-d 3769 AL Soesterberg The Netherlands
T +31-(0)346-333350
www.alpine.eu
Version 022-02

CE certified and monitored by PZT GmbH, Bismarckstr. 264B, 26389 Wilhelmshaven, #1974, Germany

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals