EMOS ZS2540 LED Floodlight SMD Instruction Manual
- June 4, 2024
- EMOS
Table of Contents
LED Floodlight SMD
Instruction Manual
ZS2540 LED Floodlight SMD
ZS2510\ZS2520
ZS2530\ ZS2540
Type| Input Voltage| Max. Power| Life Span| Luminous Flux| Dimensions| Weight|
Maximum ProjectedArea
---|---|---|---|---|---|---|---
ZS2510| 220–240 VAC50 Hz| 10.5 W| 25 000 h| 950 lm| 114 × 99 × 51| 0,201 kg|
0,01 m2
ZS2520| 21 W| 25 000 h| 1 900 lm| 147 × 123 × 55| 0,388 kg| 0,02 m2
ZS2530| 31 W| 25 000 h| 2 800 lm| 178 × 148 × 55| 0,530 kg| 0,03 m2
ZS2540| 51 W| 25 000 h| 4 600 lm| 208 × 170 × 55| 0,733 kg| 0,03 m2
LED reflector is designed for indoor and outdoor use to be mounted on firm
ground.
Ingress Protection: IP65 – for outdoor use
Mounting
Mount the lamp firmly onto a solid basis, for example, a wall (fig. 1, 2, 3).
Installation height 2.3–3 m.
Connect a power cable for connection to a 220–240 V~ power network.
The cable must not be plugged into the power network during the installation
of the spotlight.
Direct the reflector as shown in fig. 1 and 2.
L – brown – live wire
G – green&yellow – earth wire (ground)
N – blue – neutral wire
Maintenance instructions
- Before maintenance, switch off the lamp and wait until it is cooled.
- Clean it with a soft moistened cloth.
- Never submerge the lamp in water or other liquids.
- During maintenance, observe general rules for occupational safety, and be very careful.
WARNING
- The reflector is designed entirely for firm mounting.
- Before connecting to the 220–240 V~ make sure that the connecting wire is not under voltage. This operation can be carried out only by an authorized person.
- Respect a minimum distance of 1m between the appliance and the object or surface which you wish to lighten.
- If you place the reflector below the roof, keep the minimum 0.2 m distance measured from the upside of the reflector to the bottom of the roof.
- Do not use the reflector without the protection glass.
- The protection from dangerous contact voltage is ensured by „earthing“.
- The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
- Terminal block not included. Installation may require advice from a qualified person.
- Terminal block for connection of power supply: 3 terminals screw-less type, rated for cross-section range including 1 mm 2 and voltage min 230 V.
- Type Z attachment.
- Caution, risk of electric shock .
EMOS spol s.r.o. declares that the ZS2510, ZS2520, ZS2530, and ZS2540 is in
compliance with the essential requirements and other relevant provisions of
the Directive. The device can be freely operated in the EU. The Declaration of
Conformity can be found at http://www.emos.eu/download.
This product contains a light source of energy efficiency class.
Do not throw electric appliances into unsorted municipal waste, use collection
points of sorted waste! Dangerous substances from electric appliances
deposited in landfills can leak into underground waters, reach the food chain
and damage your health and well-being. For actual information about collection
points, contact the local authorities. ****
****www.emos.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>