EPSON TrueOrder Kitchen Display System User Guide
- June 15, 2024
- Epson
Table of Contents
111-56-QUM-022
Rev 3.00
Network Settings
About this guide:
This guide consists of 2 sections:
- Overview – Description of what this is in an Epson True Order Kitchen Display System (KDS).
- How to Configure – A procedure that can be followed to configure this in a KDS system.
Overview
By default TrueOrder KDS devices are DHCP enabled, allowing them to be easily
added and discovered on the local network. It may be necessary to configure
the devices to a static IP and this guide explains how to do that from the
Configurator. While the IP can be referenced from the configurator, it is also
conveniently displayed on the KDS splash screen. The splash screen is
displayed during power up and can also be displayed by pressing the logo on
the header bar for a touch screen or by pressing the Summary key 3 times using
a bump bar.
EPSON is a registered trademark and EPSON is a
registered logomark of Seiko Epson Corporation. All other product and brand
names are trademarks and/or registered trademarks of their respective
companies. Epson disclaims any and all rights in these marks. Copyright 2023
Seiko Epson Corporation.
How to Configure
This guide assumes that you already have a Single or Multi-Station system
setup as described in the Epson KDS Quick Start Guides.
Open IP Settings window for a device.
- Click STATIONS
- Select DEVICE CONFIG
- Click for the device to change IP Settings
- Click Edit IP Settings
Set new IP Settings
- Select Mode.
- If Mode is Static IP, set IP, Gateway and Subnet accordingly.
- Input Password “epson”.
- Click CONFIRM.
The new IP Settings will be applied to that device. After several seconds the
device can be accessed from the new IP. Display the splash screen by touch
screen or bump bar as described in overview to verify the new IP address.
Repeat the steps for all of the devices in the system you wish to configure.
Network Settings
Quick User Manual
111-56-QUM-022
Rev 3.00