Gudsunal WQP4-6207 Portable Countertop Dishwasher User Guide
- June 15, 2024
- Gudsunal
Table of Contents
Gudsunal WQP4-6207 Portable Countertop Dishwasher
WQP4-6207 Quick Guide
PLEASE READ THE USER MANUAL BEFORE USINF THE APPLIANCE.
INSTALLATION DIAGRAM
Notes:
- Please use cold water or warm water not exceeding 120°F.
- The inlet pipe and drain pipe can not be folded, otherwise may affect the washing effect.
- Ensure that the appliance is situated securely on the floor; otherwise it will cause overflow and electric leakage. Take the package out from appliance.
- After installation, please retain all documents and components for later use or for the subsequent owner.
WATER TANK INSTALLATION
- A. Insert the water tank suction pipe into the water inlet of the water tank according to the direction shown in the figure.
- B. After the water tank is placed horizontally on the table top, lift the machine and put it down at the groove of the water tank.
- C. After the water tank is placed horizontally on the table top, lift the machine and put it down at the groove of the water tank.
USE OF WATER TANK
Note: before adding water to the water tank, please check whether the power supply of the machine is connected; whether the drain pipe and water suction pipe of the water tank are connected properly.
- A. After pulling out the water drawer of the water tank, pour the water in the kettle. Pay attention not to pour water too fast to prevent water splashing.
- B. In the process of adding water, when the “Full” lights up on the display screen with beeping sound, it indicates that the water tank is full of water. At this time, please stop adding water and push the water drawer back to the water tank, and then press the power button to start the machine.
Warning!
The full water icon can only be illuminated when it is normally powered on!
After the full water icon is on, please do not continue to add water, which
will exceed the capacity of the water tank and cause overflow.
Please clean the water tank every month.
Please pour out the residual water in the water tank, if the water tank will
not be used for a long time.
MAINTENANCE AND CLEANING
Clean the filter assembly
After appliance ran a while, there will be some residue and other things left
in it.
Please clean it when you see the residue and things, also clean the appliance
immediately.
- A. Make sure the power is off. Turn the filter assembly out with anticlockwise. And put the filter assembly back with clockwise.
- B. Use flowing water to flush filter assembly.Do not use steel wool or iron brush, it will cause the filter rust.
Clean the spray arms
-
A. Pull the main basket out of appliance, and lift the lower spray arm a little bit for loss the clips.
-
B. Turn the upper spray arm out with anticlockwise.
And put the upper spray arm with clockwise. -
C. Check if the spray arms blocked. If it does, please use a thin wire to pull the blockages out or flush the hole with water.
ERROR CODE LIST
COMMON FAULT APPROACH
For further using doubts or confusions,pls contact our email:
service@gudsunalkitchen.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>