TECKNET EWM01233 Wireless Mouse for Laptop User Manual
- June 14, 2024
- TECKNET
Table of Contents
TECKNET EWM01233 Wireless Mouse for Laptop
Package Contents
Button Instructions
- Left Click Button
- Scroll Wheel
- Right Click Button
Technical Specifications
- Operating Frequency: 2.4GHz
- Receiver Interface: USB version 2.0
- Operating Voltage: 1.5V
- Operating Current: 10mA
- Transmission Power: 1.5dBm
System Requirements
To use this mouse, your computer must meet the following hardware requirements
and run one of the operating systems listed below.
Hardware
- PC with a Pentium processor or equivalent AMD processors
- USB 2.0
Operating System
WindowsXP, Vista, Win7, Win8, Win8.1, Win10, macOS
Note:
The scroll wheel only works under the operating systems listed above. If you
use the mouse under a different operating system, the mouse may either not
work or lose its enhanced features.
Instructions
Battery Installation:
The optical mouse uses a single AA battery (not included).
- Install the battery into the compartment, and make sure the polarity of the battery is correct. The positive (+) and negative (-) ends of each battery must match the positive (+) and negative (-) markings in the battery housing.
- Replace the battery. Open the battery compartment cover, tap the mouse slightly and the battery will drop out, ready to load new battery, make sure it corresponds with the polarity markings.
Receiver Connection:
Remove the USB Nano receiver and plug it into a free USB port in your
computer. The Plug & Play function of your system will detect that a new
device has been connected and install it automatically.
Note
The receiver can be removed and stored next to the battery compartment while
not in use.
Intelligent Power Saving (IPS):
- The mouse is equipped with Intelligent Power Saving (IPS) function.
- When the USB Nano receiver is disconnected or the PC is switched off, the mouse will automatically switch off to conserve power.
Reconnection
There is a wireless signal connection code for this mouse. High temperatures,
electro- magnetic fields or vibration may influence the code signal and
occasionally the mouse may need to be reconnected.
Both the mouse and Nano Receiver have a built-in code and one mouse can be
connected to one receiver, or several mice to one Nano Receiver.
- Take out Nano receiver from USB port, and take out the battery from mouse, then reload the battery, and plug the Nano receiver into USB port.
- Move the mouse within 50cm of the Nano receiver, press middle button and right button simultaneously for two seconds to reconnect.
- The mouse will be ready for use after reconnection.
Attention:
- To maximize battery life, it is recommended to use the mouse on a white or light color surface.
- Do not use the mouse on a glass or mirrored surface, as these surfaces will cause the mouse to fail temporarily.
- The mouse might not work smoothly on some special surfaces, such as smooth, dark or black, reflecting and 3D mouse pads surfaces.
- Avoid using the mouse on a metal surface. Metals, such as iron, aluminum or copper, shield the radio frequency transmission and may slow down the mouse presenter’s response time or cause the mouse to fail temporarily.
- If your PC has a metal case that contains aluminum or magnesium, use the mouse to the side. The display panel may interfere with the radio frequency signal if you use the mouse directly in front of the PC.
Correct Disposal of This Product
- ( Waste Electrical& Electronic Equipment ) This Marking shown on the product or its literature, indicate that it should not be disposed with other household wastes at the end of its working life.
- To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.Household user should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling.
- Business users should contact their supplier and check the terms and conditions of the purchase contact. This product should not be mixed with other commercial wastes for disposal.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Limited 12-Month Warranty
What this warranty covers.
Shenzhen Unichain Technology Co., LTD. (Manufacturer: “Unichain”) warrants to
the original purchaser of this TECKNET product that the product shall be free
of defects in design, assembly, material, or workmanship.
What the period of coverage is.
Unichain warrants the TECKNET product for 12 Months.
What will we do to correct problems?
Unichain will repair or replace, at its option, any defective product free of
charge (except for shipping charges for the product).
What is not covered by this warranty?
All above warranties are null and void if the TECKNET product is not provided
to Unichain for inspection upon Unichain’s request at the sole expense of the
purchaser, or if Unichain determines that the TECKNET product has been
improperly installed, altered in any way, or tampered with. The TECKNET
Product Warranty does not protect against acts of God such as flood,
earthquake, lightning, war, vandalism, theft, normal-use wear and tear,
erosion, depletion, obsolescence, abuse, damage due to low voltage
disturbances (e.g. brownouts or sags), non-authorized program, or system
equipment modification or alteration.
How to claim the warranty
Please contact retailers or visit TECKNET website or email
support@tecknetonline.com for more
information. To extend the warranty period, please visit TECKNET website and
register your TECKNET products within 90 days of purchase.
Disclaimer
Every effort has been made to ensure that the information and procedures in
this guide are accurate and complete, no liability can be accepted for any
errors or omissions and we reserve the right to make any changes without
further notice to any products mentioned herein.
IMPORTANT SAFETY INSTRUCTIONS-CAREFULLY FOLLOW THESE INSTRUCTIONS
- SAVE THESE INSTRUCTIONS – This sheet contains important safety and operating instructions.
- Before using the product, read all instructions and caution markings on the product, accessories and device using our product.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Keep the product away from fire or explosion may occur.
- Do not place product in or near inflammable, explosive or hazardous object.
- Do not place in or near water, rain, excess moisture or extreme heat.
- Do not operate product with damaged cord or plug.
- Do not operate product if it has been damaged in any way.
- Do not disassemble the product. Disassembly may result in a risk of safety hazards.
- Do not throw or shake the product.
SIMPLIFIED EU DECLARATION OF CONFORMITY
- Hereby, Shenzhen Unichain Technology Co., Ltd. declares that the product type EWM01233 is in compliance with Directive 2014/53/EU.
- The full text of the EU declaration of conformity is available at the following internet address: https://eu.tecknetonline.com/.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>