S BAGNO UKM3111-12070TDM Bathroom Mirror with LED Lights Instruction Manual
- June 14, 2024
- S bagno
Table of Contents
**S BAGNO UKM3111-12070TDM Bathroom Mirror with LED Lights Instruction Manual
**
Technical information
Size: 60X60cm
Input: 220V
Power: 25W
Ra: >80
LED: SMD2835/204PCS
Lumen: 1900LM
CCT: 6500K/3000K/4000K
Kits coming with the mirror
-
Expansion Tube
-
Screw
-
Junction Box
Tools needed for installation
-
Pencil
-
Screw Driver
-
Rubber Mallet
-
Electric Dril
-
Tape Measure
Installation steps
Measure the distance between the two brackets on the back of the mirror and use a level to mark the same distance on the wall.
Use a hammer to drive the pastis anchors into the hole drilled with an electric drill, then use the electric drill to screw the crews into the plastic anchors’
Connect the wall power cord to the wires behind the mirror through the junction box.
Align brackets behind the mirror with the screws on the wall and hang it, installation is completed.
Instructions for use
The mirror is equipped with 3 touch sensor switch, when installation finished
and power connected, the
touch sensor light will be on, it can be turn off by long press when the light
is off.
For LED Light
First touch sensor is for the light, one click for light on/off, long press for dimming.
For Demister Pad
Second touch sensor is for the demister pad, before having a shower we can
turn it on, when we finish
the shower, the demister pad area would be clear without any fog. Turn if off
before leaving.
For LED Magnifying Mirror
Third touch sensor is for lighting up the magnifying mirror, one click for light on/off. The magnifying mirror with light can zoom on your facial features when putting eyeliner, eyelash, lipstick and shaving, make sure that every detail of your hair and makeup are appropriate
Warning
- Disconnect from outlet before putting on or taking off parts.
- Close supervision is necessary when this mirror is used by, or near children.
- Keep the cord away from heated surfaces.
- Make sure that the electricity is turned off at the power source before proceeding with the installation.
- Always unplug all the power supply cords from before moving the product, testing the product, or repairing the product.
- Do not use outdoors.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>