TooQ FS20404HM-B Ares Floor Stand User Manual
- June 14, 2024
- TooQ
Table of Contents
TooQ FS20404HM-B Ares Floor Stand
Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.
CAUTION
- Use with products heavier than the rated weights indicated may result in instability causing possible injury.
- Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
- Safety gear and proper tools must be used. This product should only be installed by professionals.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Use the mounting screws provided and DO NOT OVER-TIGHTEN mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Required for Installation
Parts List
IMPORTANT:
Ensure that you have received all parts according to the component
checklist prior to installation. If any parts are missing or faulty, contact
your place of purchase for a replacement.
Hardware List
Installation Instruction
Installing the Wheel Caster
NOTE:
Each caster can be adjusted independently for fine-tuning. Slightly turn the
nut to lower or raise the base.
Adjusting the Columns
The line on the column indicates the highest position for height
adjustment.
- Attach the handle to the column marked with “1”.
- Attach the handle to the column marked with “2”.
- Turn the handle to make the inner column run upwards to the highest position. NOTE: With the “1” and “2” marks facing forward.
Attaching the Driving Rod to the Two Columns
- Adjust the hexagon bar and make the ends of it keep 40mm from the driving rod then tighten the screws to secure.
- Attach the driving rod to the two columns.
Attaching the Columns to the Base
- Attach the columns to the base using the screws.
Installing the Crossbar
- Attach the crossbar to the columns with the appropriate screws. Tighten all screws using a proper Phillips screwdriver.
- Press the metal tab to lock the caster.
- When the crossbar installation is completed, tighten the bottom screws using an Allen key.
Installing the Universal Plate
- Attach the universal plate to the columns with the appropriate screws, washers, and butterfly nuts.
- Tighten all screws and butterfly nuts.
Adjustment
- Use the handle to adjust the columns to the desired height and secure using the appropriate screw.
- Tighten the screw Q to fix the crank handle, to prevent loosening of the handle leading to a accidental height adjustment.
Installing the Adapter Brackets
For Flat Back Screens
For Screens with Irregular Back
Note: Choose the appropriate screws, washers, and spacers (if necessary) according to the type of screen.
- Position the adapter brackets as close as possible to the center of the display.
- Screw the adapter brackets onto the display.
Tighten all screws but do not over-tighten.
Hooking the Display onto the Universal Plate
- Hook the display onto the universal plate.
- Tighten the bottom screws to secure them.
IMPORTANT:
Make sure the display is mounted correctly and the screws are tightened safely
before releasing the display.
Installing the Camera Shelf
Installing the DVD Shelf
- Install the support bar to the columns at the desired position and secure using the appropriate screws.
- Attach the DVD shelf to the support bar with the appropriate screws and butterfly nuts.
- Tighten all screws and butterfly nuts to secure.
Note:
It is recommended to adjust the columns to the desired height before
installing the display.
Maintenance
- Check if the bracket is secure and safe to use at regular intervals(at least every three months).
- Please contact your distributor if you have any questions.