MOMAN C1X Wireless Lavalier Microphone User Manual
- June 14, 2024
- MOMAN
Table of Contents
MOMAN C1X Wireless Lavalier Microphone User Manual
Caring For Your MOMAN Product Product Introduction
- Please keep the product in a dry, clean, dust-free environment.
- Keep corrosive chemicals, liquids and heat source away from the product to prevent mechanics damage.
- Use only a soft and dry cloth for cleaning the product.
- Malfunction may be caused by dropping, impact of external force.
- Do not attempt to disassemble the product. Doing so voids warranty.
- Please have the product checked or repaired by authorized technicians if any malfunctions happened.
- Failure to follow all the instructions may result in mechanics damage.
- Warranty does not apply to human errors.
Package List
-
TX Transmitter x2
-
RX Receiver x1
-
3-in-1 Charging Cable x1
-
External Lav Mic (With Wind Muff)
-
Mic Windshield
-
Eject Pin x1
-
Carrying Bag x1
-
3.5mm TRS Camera Cable x
-
3.5mm TRRS Phone Cable x1
Product Introduction
- TX Transmitter
1. External Mic Input
2. USB-C Port
3. Power
4. Reset (Help with Eject Pin)
5. Low Cut
6. Pairing
7. Built-in Mic
8. Pocket Clip
9. Pairing Indicator
10. Power Indicator
- RX Receiver
1. USB-C Port
2. Power (Mono/Stereo Switch)
3. Reset (Help with Eject Pin)
4. Channel A Gain Control
5. Channel B Gain Control
6. 3.5mm Audio Output
7. 3.5mm Monitoring Jack
8. Pocket Clip
9. Pairing Indicator
10. Power Indicator
Indicator
| Power Indicator (Green)| Pairing Indicator (Blue)
---|---|---
Slow Flashes| Power is lower than 10%.| Power on
Fast Flashes| /| System pairing
Keeps On| It stays green when charging and is offafter fully charged.| System
paired
Fast flashes twice, isoff and repeats| /| Low cut function is on.
Power Button
Long press the power button for 2 seconds to turn on/off the system. Short press the power button on the RX for Mono/Stereo switch.
Pairing
The system will pair automatically after power on. If you need manual pairing, long press the channel A gain control and channel B gain control on the RX, and the pairing button on the TX, the system will start to pair.
Connection
The receiver outputs audio signals to recording devices with a 3.5mm TRRS Phone Cable or a 3.5mm TRS Camera Cable. Please use the corresponding cable based on your device.
Installation
Attach the transmitter or the external mic to the speaker’s clothing. Install
the receiver to the camera’s hot shoe via the pocket clip.
(Note: When using the external mic, please insert it into the mic input
properly.)
Gain Control
The initial value of the gain is the microphone’s original volume. Each press
of the gain control button increases the gain by one level, fourth level at
most. When the gain is at max level, press once and return to initial value.
Charging
Please fully charge the TX and RX via the USB-C port and the charging cable
before use
Setting The Recording Level Correctly
Camera devices generally have poor-quality, noisy preamps. In order to get the
cleanest signals possible, it is highly recommended that you set the recording
level on your camera quite low, 1/2 or 1/3 of it. The product provides
variable gain control, allowing you to tailor your levels to just about
environment and recording device.
Adjust the recording level of inbuilt mics for SONY Camera (Take A7S Ⅱ for
example)
Adjust the recording level of inbuilt mics for Canon Camera (Take EOS 5D Mark
Ⅳ for example)
Adjust the recording level of inbuilt mics for Panasonic Camera (Take LUMIX
GH5 for example)
Specifications
TX Transmitter
Wireless Transmission: Digital 2.4GHz
RF Frequency Band: 2400-2483.5MHz
Working Distance: 164ft/50m (LOS area), 98ft/30m (NLOS area)
Latency: 12.5ms
Mounting: Pocket Clip
Audio Input: 1/8″ / 3.5 mm TRS Mic Input
Audio Input Level: 1V (0dBV)
RF Output Power: <10mW
Power Requirements: 3.3V-4.7V
Battery Type: Built-in Lithium Battery
Battery Charging Time: 1.5H
Battery Life: 8H
Dimensions: 52X42X16mm
Material: Plastic
Weight : 35g
RX Receive
Wireless Transmission: Digital 2.4GHz
RF Frequency Band: 12.5ms
Approximate RF Sensitivity: 2400-2483.5MHz
Working Distance: 164ft/50m (LOS area), 98ft/30m (NLOS area)
Latency: 12.5ms
Mounting: Pocket Clip
Number of Audio Channels: 2
Audio Output: 1/8” / 3.5 mm TRS Mic Output
1/8” / 3.5 mm TRS Headphone Output
Gain: 0-4 Level (0 to 8dB)
Audio Output Level: Line Out: 1V, Monitoring: 25-30mW
Power Requirements: 3.3V-4.7V
Battery Type: Built-in Lithium Battery, 400mAh
Battery Charging Time: 1.5H
Battery Life: 8H
Dimensions: 52X42X16mm
Material: Plastic
Weight: 35g
Microphone
Sound Field: Mono
Polar Pattern: Omnidirectional
Frequency Range: 50Hz-20KHz
Sensitivity: -40dB (±3 dB, re 1V/Pa at 1KHz)
Maximum SPL: 135dB SPL (at 1KHz)
Moman (UK) Limited
Unit 25 Basepoint Business Centre, Aviation Park, West Christchurch, United
Kingdom BH23 6NX
www.momanmic.com
www.momanx.com
www.momanx.co.uk
@MomanGlobal https://moman.co/youtube
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>