iHEAT Heated Insoles Electric Heated Insoles Remote Foot Warmers User Manual

iHEAT Heated Insoles Electric Heated Insoles Remote Foot Warmers

Product Information

Specifications

• Voltage: 3.7V
• Battery capacity: 3500mAh
• Charging voltage: 5V2A
• Power output efficiency: 98%
• Overcharge protection voltage: 4.2V
• Overload protection voltage: 2.85V
• AC Adapter Specifications:
  • Charging mode: CC / CV
  • Charging temperature: 0~45°C
  • Input: AC / 100V-230V 40-60Hz
  • Output: 4.2-5V 500*2

Product Usage Instructions

Care Instructions

Spot clean only. Dry flat. Do not bleach, iron, or wring. Fully dry the insoles before turning them on.

Battery Care

After the battery is used up, charge it within 24 hours to maintain its life and startup. Turn off the product when not in use to save power. It is recommended to fully charge the battery during storage (charge it at least 3 times per month).

Operating Instructions

1. Read the instruction manual carefully before using the heated insoles.
2. Operate the heated insoles under the correct guidance.
3. If you feel uncomfortable while wearing the insoles, take them off immediately.
4. Contact the After-sales Service for further assistance if needed.

Cleaning Instructions

The front and middle parts of the insoles can be washed. Wipe or scrub the battery port as much as possible. Do not soak the insoles in water.

Charging and Working Time

1. Turn off the insoles before charging them.
2. Plug the two charging cable plugs into the USB port on the back of the insole.
3. When charging, the red light will be on. After approximately 3 hours, the red light will turn off.
4. Do not charge the insoles while they are powered on.

Tips and Warnings

After receiving the product, follow these steps to test its heating capabilities:

1. Turn on the insoles.
2. Use the remote control or temperature adjustment button on the insole to set it to high temperature mode.
3. Place the insole in a small closed box or quilt for 10 minutes.
4. Check if the heating area in the center of the foot heats normally and meets your needs.
5. If everything is satisfactory, cut the product according to your feet size.

FAQ

Q: Can I cut the insoles below the provided cutting line?

A: No, do not cut below the provided cutting line to ensure proper functionality.

Q: How often should I charge the battery?

A: Fully charge the battery every 3-6 months, and it is recommended to charge it at least 3 times per month during storage.

Q: What should I do if the insoles become uncomfortable to wear?

A: If you feel uncomfortable while wearing the insoles, take them off immediately and contact our After-sales Service for assistance.

Q: Can I charge the insoles while they are powered on?

A: No, it is forbidden to charge the insoles while they are powered on. Please turn them off before charging.

www.iheatgroup.com
iheatstore@hotmail.com

Package List

About Battery

After the battery is used up, please charge the battery within 24 hours. Failure to charge it in time will seriously affect the battery’s life and startup. When not using the product, please turn it off to save power.
Please fully charge it during storage.(It is recommended to charge it 3 times in one month.)

WARNING
Please read instruction carefully and operate the heated insoles under the correct guidance, Failure to follow the instructions or operating the heated insoles in dangerous environment may results in injury. If you feel uncomfortable when you wear it, please take off the insoles immediately. you would be better to contact with our After-sales Service for more help.

Operation Instructions

Key operation on the insole buttons

• a. When putting in the shoes, press the insoles ” “button for 3 seconds.
• b. After turning on, press the button on the insole to adjust the temperature.
  • Press “H” =High temperature(Red light), about 131-149°F;
  • Press “M”=Medium temperature(Yellow light), about 122-131°F ;
  • Press “L”=Low temperature (Green light),about 104-114°F;
• c.Turn-off:Press and hold the insoles on/off “ “button on the insole for 3 second.

Estimated Heating Time

• Red Light-Highest temp ( 55 -65°C/ 131-149°F ,5.5-6 hours)
• Yellow Light-Medium temp ( 50-55°C/122-131°F ,7-8 hours)
• Green Light-Lowest temp ( 40-45°C/ 104-114°F ,10-11 hours)
• Charging And Working Time
• Please turn off and recharge it.
• You need to plug the two charging cable plugs connected to the charger into the USB port on the back of the insole.
• When charging, the red light will be on.
• After about 3 hours, the red light will be off.
• Note: It is FORBIDDEN to charge when POWER ON.

About Cleaning

Because this product has a built-in lithium battery, it can’t be soaked in water and not allowed to be soaked in water. The front and middle part can be washed, and the battery port should only be wiped/scrubbed as much as possible.
It is forbidden to soak in the water.
Note: This product is not allowed to be soaked in water

Specifications

• Voltage: 3.7V

• Battery capacity: 3500mAh

• Charging voltage: 5V2A

• Power output efficiency: ≥98%

• Overcharge protection voltage: 4.2V

• Overload protection voltage: 2.85 V
  AC Adapter Specifications

• Charging mode: CC /CV

• Charging temperature; 0℃~ 45℃

• Input: AC / 100V-230V 40-60Hz

• Output 4.2-5V 500*2

Tips and Warnings

After getting this product, turn it on, then use the remote control or the temperature adjustment button on the insole to adjust the high temperature mode, then put the insole in a small closed box or quilt for 10min, and pay attention the center of the foot in the heating area, if it can heat normally and can meet the needs, then cut the product according to your feet size.

www.iheatgroup.com
iheatstore@hotmail.com

References

• Home - iheat

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>