EAST OAK PBU23001 Offset LED Patio Umbrella Owner’s Manual

EAST OAK PBU23001 Offset LED Patio Umbrella

IMPORTANT CAUTION

Please check all parts and components to ensure no damage or missing items before starting the product’s construction. If you have any problems or discover any missing parts, please contact customer service at support@eastoak.com.

• Some parts may contain sharp edges. Wear protective gloves if necessary during assembly.
• When using power tools, please adjust the gear to the minimum. Otherwise, it will cause damage to the parts.
• Assemble on a soft surface such as a drop sheet or rug to avoid scratching.
  

SAFETY GUIDE

• Patio umbrellas are only designed to protect from the sun, NOT the wind.
• NEVER open or operate this umbrella in wind conditions greater than 5mph (8kph).
• NEVER use the tilt function in any wind (even a light breeze).
• NEVER use excessive force on the crank handle to open or close the umbrella.
• ALWAYS close and secure the umbrella when not in use or during any strong wind event, especially gusting wind and rain.
• ALWAYS close the umbrella when unattended or not in use. If you are not sitting under it, the umbrella should be closed.
• ALWAYS use the Velcro straps to properly secure the canopy to the frame when the umbrella is closed.
• Base weights are required (additional purchase) to secure this umbrella.
• NEVER open or operate the umbrella without first placing base weights in each open section of the cross base. It is important to use a correctly weighted base; more weight is always better than less weight. This model requires a
  MINIMUM base weight of 192 lbs. (88 kg).

FAILURE TO CAREFULLY OBSERVE THESE SAFETY WARNINGS CAN RESULT IN CATASTROPHIC DAMAGE TO YOUR UMBRELLA, POTENTIAL PERSONAL INJURY, AND OR PROPERTY DAMAGE.

IMPORTANT INFORMATION

Suppose the umbrella shows ANY signs of stress or moves around excessively even when adequately weighted. In that case, it indicates the wind is too strong, and the umbrella must be closed and secured immediately

CARE AND MAINTENANCE

• To help extend the life of the polyester fabric and reduce the effects of fading, we strongly advise using a protective storage cover whenever the umbrella is not being used.
• During extended periods of bad weather (especially through winter months), your umbrella should be stored inside in a dry place.
• The polyester fabric has been treated to make it dirt and shower-resistant (not waterproof). If your umbrella gets wet, please allow it to fully dry before storing it away. The fabric can be cleaned with a soft brush, then use a damp cloth and mild detergent to remove any stubborn stains.

PARTS LIST

• Lower Cross Base
  A (X1)
  
  

• Upper Cross Base
  B (X1)
  

• Central Spigot
  **C (X1)

**

• Hex Bolt M8*20mm
  **D (X4)

**

• Washer M8
  **E (X4)

**

• Main Frame and Canopy
  F (X1)
  

• Solar Panel
  G (X1)

• Wrench M8
  H (X1)

• Spare LED Light Covers
  I (X3)
  

ASSEMBLY INSTRUCTIONS

1. Place the upper cross base (B) over the lower cross base (A)

2. Using the M8 wrench to install the central spigot on the assembled cross base with 20mm M8 hex bolts and M8 washers.
   

3. Locate the plug at the top of the umbrella. Then, carefully insert the plug into the solar panel’s underside socket.
   

4. Place the solar panel on the top of the umbrella, taking care to conceal the wires inside the gap at the top, then gently turn the solar panel in a clockwise direction to attach it to the umbrella. Do not over-tighten, as this may damage the umbrella and the solar panel.
   

5. Place the assembled cross base in your preferred location, then follow the ‘Cross Base Installation Tips’ on pages 16-17.
   
   

6. Attach the main frame and canopy to the central spigot. Ensure the locating pin is positioned into the cutout at the top of the central spigot.
   Tighten the tension screw firmly.
   NOTE: The central spigot is designed with a reverse angle to ensure the canopy sits level once assembled. It is essential to correctly locate the crank winder directly above the tension screw, as shown.
   
   Locate the umbrella in direct sunlight to charge the batteries before first use.
   IMPORTANT NOTE: Charge the batteries for at least 8 hours in direct sunlight before first use. Failing to follow this step will shorten the lifespan of the rechargeable batteries and decrease the performance of the lights. Make sure the switch on the rib is set to the “OFF” ‘O’ position during charging.
   

OPERATING INSTRUCTIONS

1. Unfasten the Velcro storage straps from the canopy and main frame.
   

2. Unlock the lift clamp. Gently slide the arm upwards to extend the umbrella fully
   

3. When the umbrella arm is fully extended, lock the lift clamp and slide the lock cover into place as shown.
   

4. Turn the crank handle in a clockwise direction to open the canopy (take care not to keep winding the crank handle once the canopy is fully opened).
   

5. To close the umbrella, first, undo the tie strings and then wind the crank handle gently in a counterclockwise direction until the canopy is fully closed.
   CRITICAL STEP: Always remember to slide the lock cover away from the vertical lift mechanism BEFORE lowering the umbrella arm. Unlock the lift clamp and gently slide the arm downwards to lower the umbrella fully. Fasten the Velcro storage straps around the canopy and main frame.
   NOTE: A regular application of silicone spray to the sliding mechanisms will assist with smooth operation.
   

OPERATING THE LIGHTS

1. To operate the lights, turn the switches (located on the end of one rib) to the ON (‘I’) position.Ensure the switch on the rib is set to the “OFF” (O) position when lights are not being used.
   IMPORTANT: If the lights are accidentally left on during the day, the batteries will NOT charge and the lights will not operate at night.
   ****

REPLACING THE BATTERIES

The batteries in your LED umbrella must be replaced at least once every year (or when you feel that the light is fading more quickly). You can purchase replacement batteries at specialty retailers. You will need 3 AA size 1.2v 1200mAh NIMH rechargeable batteries rechargeable batteries which are the same as have been supplied with your purchase.

Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause them to leak.

• NEVER dispose of batteries in the fire. Batteries must be recycled or disposed of as per state and local guidelines.
• NEVER mix old and new batteries.
• NEVER mix Alkaline, Standard (Carbon-Zinc) or rechargeable (Nickel Cadmium), or (Lithium) batteries together in the solar panel.

1. Twist the solar panel counterclockwise and remove it from the top of the umbrella.

2. Carefully pull the plug out of the socket under the solar panel.
   IMPORTANT: Do not pull the wire to remove the plug.
   
   

3. Set the solar panel upside down on a soft, clean surface to avoid scratching.
   Loosen all three screws on the bottom of the solar panel.

4. Carefully open the solar panel. Replace the batteries, matching the +/- on the battery with the +/- on the battery case.

5. Make sure the O ring is correctly located before replacing the cover.

6. Re-assemble the solar panel. Do not over-tighten the screws.

OFFSET UMBRELLA BASE TIPS

STANDARD INSTALLATION

• The cross base supplied with this offset umbrella requires 4 individual base weights of at least 48 lbs. (22 kg) each for a minimum combined weight of 192 lbs. (88 kg) to provide the necessary support and stability. As a general rule, the more weight, the better the umbrella will be supported.
• Failing to use the minimum base weight will damage the umbrella and may also cause personal injury

SPECIAL INSTALLATION

• If you have a suitable timber deck, the cross base can be secured to it using 2” (5cm) M8 coach bolts or deck screws (not supplied). Ensure the fixing points are made into joists or bearers, not just the decking boards. If using this option, extreme care must be taken to ensure the umbrella is never opened or used in winds greater than 5mph.

FEATURES

• SOLAR-POWERED LIGHTS: Use day or night with 40 built-in solar LED lights and a center LED light. Lights can run for 6-7 hours simultaneously.
• HIGH-DURABILITY FABRIC: The umbrella is made of 100% polyester, fade-resistant, UV-protective, water repellent fabric to keep the people enjoying food or drink under the umbrella comfortable.
• EXCELLENT FUNCTION: This umbrella’s 10-foot diameter gives you enough shade for the courtyard, patio, outdoor garden, beach, or any other outdoor situation.
• STURDY STRUCTURE: A 2.28-inch diameter Ferro pole and 8 heavy-duty ribs with rust-free powder-coated steel frame ensure strong wind resistance, durability, and stand up to the sun. The umbrella has an added wind vent top for airflow and reduced wind pressure to enhance stability.
• EASY TO USE: For more flexibility, this item easily inclines, making it easy for you to adjust its angle according to the sun’s position. Crank handle for easy opening and closing, which makes it easy to raise and lower the canopy

WHAT’S IN THE BOX

• 1 X Lower Cross Base
• 1 X Upper Cross Base
• 1 X Central Spigot
• 4 X Hex Bolt M8*20mm
• 4 X Washer M8
• 1 X Main Frame and Canopy
• 1 X Solar Panel
• 1 X Wrench
• 3 X Spare LED Light Covers
• 1 X Owner’s Manual

TECHNICAL SPECS

• Construction Materials: 180g Polyester Canopy, Aluminum Pole, and Steel Ribs.
• Assembly Time: 5-10 minutes
• Product Size:
  • Umbrella Ribs: 8 steel rib
  • Umbrella Pole Diameter: 2.28 inch
    

WARRANTY AND SERVICE

GUARANTEED 3-YEAR WARRANTY
Thank you for choosing East Oak. This product is covered by our company warranty for up to 3 years from its original purchase date.

CLAIM WARRANTY
If you’d like to claim your product’s warranty, register your new product on our website at www.eastoak.com/warranty

Customer Support

Questions? Comments?

Reach out to us for expert support!
support@eastoak.com
eastoak.com
1-833-EAST-OAK (USA)
(1-833-327-8625) Mon-Fri 8am-8pm EST
Follow eastoakliving on

support@eastoak.com
eastoak.com
1-833-EAST-OAK (USA)

References

• East Oak / Patio life elevated

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>