XingYida B7 Bluetooth Headset Waterproof User Manual

XingYida B7 Bluetooth Headset Waterproof User Manual

Thank you for purchasing and using these Bluetooth headphones! Please pair it with Bluetooth enabled computers, laptops, cellphones or tablets by

following steps:

1. Press the headphones power switch button to turn it on
2. Enable device’s Bluetooth function;
3. Search for the BT device and select “B7”: Settings->Bluetooth->My Devices If paring is successful, the blue light indicator starts flashing (the headset said: Connected). Please make sure the headphone is off before pair. It will connect to the pre-set phone automatically when turns on(Please make sure the BT function of your phone is on). If the pairing is not successful, please check whether B7 has paired with some other Bluetooth devices nearby. If yes you need to turn off that device’s Bluetooth function first then pair it with your phone again If not please switch off the headphones firstly, and then re-pair again

Precautions for Charging

Insert Type C charging cable into Type C port which has support 5V power (such as AC/DC Type C adapter or PC Type C port). Please note that input voltage is DC5V, better not higher than 5V, otherwise it may bum out the headphones. It takes about 2 hours to charge the headphones fully

Keys operations

| Long press (5 seconds), switch on/off|

| Long press (1.5 seconds) to turn on the voice assistant
---|---|---|---

| Short press, music pause/play|

| Short press to answer/hang up

| Press twice in a row to redial the nearest phone number.|

| Long press (2 seconds) to refuse to answer the phone.

| Short press to increase the volume|

| Long press (2 seconds) to play the next song

| Short press to reduce the volume|

| Long press (2 seconds) to play the previous song

LED indicator

Parameters

FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>