ValueMax V024004A 3 In 1 Staple Gun Instruction Manual

3 In 1 Staple Gun

WARNING
Read instructions carefully before operating staple gun and save them for future reference. Tool operator and others in work area should always wear safety glasses to prevent serious eye injury from fasteners and flying debris when loading, operating or unloading this tool.

FITS

TO OPERATE
Hold staple gun and press the release latch to pull out the loading rod as shown in Fig.1.
Place stick of selected staples into channel as shown in Fig. 2, then replace the loading rod, be sure it is firmly installed as shown in Fig. 3.
NOTE: Channel allowed to install staples not more than 7cm long in total.
Place staple exit area where staple is to be driven. Grasp tacker with fingers through opening and depress handle until mechanism release and drives staple. For best results, hold staple gun so downward pressure keeps exit area firmly against material being stapled.
TO ADJUST THE STRENGTH
Rotate the strength setting knob to adjust the depth of the staples as shown in Fig. 4.
TO CLEAR OR UNLOAD:
Pull back the metal drive channel switch and open as shown in Fig. 5, remove
jammed staples or unload, close as when opening.
TO LOCK HANDLE DOWN
FOR STORAGE:
Be sure staple gun is unloaded. Hold handle down and engage handle lock, see Fig. 6.

SAFETY INSTRUCTION

Keep out of reach of children.
Never aim staple exit at any boby !
Wear safety glasses when operating tacker.
Know what materials you are stapling. Watch out for potential hazards such as
electrical wires.
Do not over reach so as to cause loss of balance or loss of secure footing

STAPLE LENGTH GUIDELINES

1/4″ 6mm| Can be used on window screens & shades, light draperies, shelf papers, closet lining, etc.
---|---
5/16″ 8mm| Can be used on light upholstery and other relatively thin materials.
3/8″ 10mm| Can be used on insulation, weather stripping, wire mesh, carpet pads, canvas and other materials of moderate strength where material thickness is up to about 3/16″ maximum.
1/2″ 12mm 9/16″14mm| Can be used where thickness of material being stapled is substantial, for example, foam insulation board or heavy folded draperies(about 1/4″(6.3mm) to (9.5mm) thick). (For cable 6mm max wire dia 50 v max voltage)

TACKER: APPLICATIONS
Low Voltage Cabling (for cables less than 6mm Dia and 50V Max)

• Holiday Light
• Antenna wiring| • Telephone Wiring
• Alarm system wire|  • Cable TV
• Audio System
---|---|---

CANVAS/SCREEN APPLICATIONS

• Upholstering
• Decor
• Wire
• Stretching Canvas-Art
• Mesh/Screening
• Framing
• Framing Fabric
• Needlepoint

BRAD LENGTH GUIDELINES

NOTE
DO NOT ATTEMPT TO DISASSEMBLE/REASSEMBLE THIS TOOL. REPLACEMENT PARTS ARE NOT AVAILABLE. THE TOOL HAS BEEN. DESIGNED FOR PROFESSIONAL DURABILITY IN NORMAL APPLICATIONS WITHOUT THE NEED TO REPLACE PARTS.
WARNING
DO NOT STAPLE LIVE WIRE

Hangzhou Great Star Industrial Co., Ltd.
No.35 Jiuhuan Road, Jiubao Town,
Hangzhou 310019, China
www.greatstartools.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>