Waterdrop RF10-UF 0.01 Micron Replacement Filter Cartridge Instruction Manual

Table of Contents

Waterdrop-RF10-UF-0.01-Micron-Replacement-Filter-Cartridge-
product

Specifications

Operating temperature: 2-38°C / 35-100°F
Working pressure: 10-100psi (0.7-6.8bar)
Flow rate: 0.75gpm (2.83lpm)
Filter capacity:
- WD-RF10-UF/MZ: up to 11,000 gallons
- WD-RF15-UF/MZ: up to 19,000 gallons
- WD-RF17-UF/MZ: up to 24,000 gallons
Feed water requirement: Municipal tap water

Precautions
Before proceeding with the installation or replacement of the filter, please keep the following precautions in mind:

It’s recommended to turn off the water supply and turn on the faucet to release the water pressure.
Rotate 1/4 turn to the left to remove the filter.
Take out the new filter and remove the protective cap.
Rotate 1/4 turn to the right to install the filter. Ensure that the filter’s triangle mark is aligned with the connection mark.
Turn on the cold water valve and flush for 5 minutes.

Filter Replacement

Turn off the water supply and turn on the faucet to release the water pressure.
Rotate the existing filter 1/4 and turn to the left to remove it.
Take out the new filter and remove the protective cap.
Rotate the new filter 1/4 turn to the right to install it. Ensure that the filter’s triangle mark is aligned with the connection mark.
Turn on the cold water valve and flush for 5 minutes to remove any air or impurities.

Frequently Asked Questions (FAQ)

Q: Why doesn’t the TDS value lower after filtration?
A: The main purpose of this Waterdrop filter is not to remove TDS. TDS stands for total dissolved solids, and it is basically composed of inorganic salts and a small amount of organic matter. The filter can remove harmful substances while keeping beneficial trace elements. Please choose the Waterdrop RO system if you are looking for physical removal of TDS.
Q: When should I replace the filter?
A: The filter’s service life is related to the water quality. If the flow rate is significantly reduced or if the water has a peculiar smell, we suggest that you replace the filter. The recommended service life of the filter is as follows: 1 year for WD-RF10-UF, WD-RF10-MZ, 2 years for WD-RF15-UF, WD- RF15-MZ, 3 years for WD-RF17-UF, WD-RF17-MZ.
Q: Why does my water taste bad?
A: The filter will produce an unpleasant odor if it hasn’t been used for a long time, especially for WD-RF10-UF, WD-RF15-UF, and WD-RF17-UF. If such a problem occurs, please flush the filter for 5 minutes before use. It could also be time to change the filter cartridge.

Manufacturer Technical Support

Made in China V001 Qingdao Ecopure Filter Co., Ltd.

Replacement Filter for Undersink Water Filtration System

WARNING
Please read it carefully before installation.

The system and installation shall comply with applicable state and local regulations.

WD-RF15-UF/MZ: up to 19,000 gallons
WD-RF17-UF/MZ: up to 24,000 gallons
Feed water requirement| Municipal tap water

Note:

If using well water as the source, please make sure the feed water has been through a pre-filtration system, otherwise, large particles in well water will clog the filter easily and shorten filter life.
The above form lists model numbers of only black filters. Please note that the white filter is different from the black filter only \in color. They have the same filter material and filtration capacity.
Actual filter life varies according to local water quality.

Do not use it with water that’s microbiologically unsafe or of unknown quality without adequate disinfection.
For use only with cold water.
Do not freeze the filter, as this can cause cracking and water leakage.
Do not allow children under 3 years old to have access to small parts during installation of this product.
This installation must comply with all applicable state and local regulations.
Turn off the water supply while replacing the filter.

It’s recommended to turn off the water supply and turn on the faucet to release the water pressure.
Rotate 1/4 turn to the left to remove the filter.
Take out the new filter and remove the protective cap.
Rotate 1/4 turn to the right to install the filter. Ensure that the filter’s triangle mark is aligned with the connection mark.
Turn on the cold water valve and flush for 5 minutes.

Q: Why doesn’t the TDS value lower after filtration?
A: The main purpose of this Waterdrop filter is not to remove TDS. TDS stands for total dissolved solids, and it is basically composed of inorganic salts and a small amount of organic matter. The filter can remove harmful substances while keeping beneficial trace elements. Please choose the Waterdrop RO system if you are looking for physical removal of TDS.
Q: When should I replace the filter?
A: The filter’s service life is related to the water quality. If the flow rate is significantly reduced or if the water has a peculiar smell, we suggest that you replace the filter. The recommended service life of the filter is as follows: 1 year for WD-RF10-UF, WD-RF10-MZ, 2 years for WD-RF15-UF, WD- RF15-MZ, 3 years for WD-RF17-UF, WD-RF17-MZ.
Q: Why does my water taste bad?
A: The filter will produce an unpleasant odor if it hasn’t been used for a long time, especially for WD-RF10-UF, WD-RF15-UF, and WD-RF17-UF. If such a problem occurs, please flush the filter for 5 minutes before use. It could also be time to change the filter cartridge.

Manufacturer Technical Support