ARPELLA LEDCM3436 Frameless Wall Mounted LED Vanity Mirror Instruction Manual
- June 3, 2024
- ARPELLA
Table of Contents
ARPELLA LEDCM3436 Frameless Wall Mounted LED Vanity Mirror
Please read these instructions carefully before installation. Installation should be carried out by a qualified electrician. Do NOT strike mirror glass with hard or pointed items. It is recommended that the product is cleaned with a soft, dry, nonabrasive cloth. Do NOT use cleaning agents or abrasive materials on any type of finished surface. Do NOT allow moisture to come into contact with the electrical components.
Touch Switch Application
- LED Light Turn On/Off, Dim Short touch to turn on the LED light, then once again to turn it off When the LED light is on, hold to dim, or let go and hold again to increase the brightness.
- Adjust the color temperature When the LED light is ON, use a single finger to touch and hold, the color temperature will be changing—change from white to a cool or warm tint.
- The Switch is with memory function When the light is turned on again, the brightness and color temperature of the LED light will be at the same status as it was turned off.
- Anti-fog function- Turn On/Off Short touch to turn Off the Switch indicator light of the defogger, and the anti-fog function will be activatedShort touch again to turn On the Switch indicator light, and the defogger will stop working.
DIMENSION
INSTALLATION
- Before your installation, make sure the location of the mirror is suitable, ensuring that the domestic main power supply is within reach of the electrical entry point of the mirror.
- Use a soft pencil to mark the position of the mirror on the wall, and it is very important to make sure it is level. Remove the mirror and mark the mounting points. Keep in mind that all marked mounting points to be matched up with the fixing points on the mirror accurately.
- Drill holes in the marked positions by using a suitable tool, and then insert the wall plugs on the surface of the wall. After that, fasten the supplied screws to wall plugs(Fig.1/2/3).
- You must have a Junction box in the wall. Carefully connect the domestic main power supply to the terminal box according to the wiring diagram (Fig4) overleaf. Always remember that the domestic electrical main power supply to which the mirror is being connected is TURNED OFF during the installation. Wiring from light fitting House Wire Black(Live/Hot) to Fixture Wire Black(L) House Wire White(Neutral) to Fixture Wire White(N) House Wire Green(Ground) to Fixture Wire Green( The input voltage required is 110V.
- Hang the mirror on to the marked position,turn on the domestic electrical main power supply for the mirror light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>