Hunter SP-WVL Solar Panel for Wireless Valve Link Systems Installation Guide
- June 14, 2024
- Hunter
Table of Contents
Hunter SP-WVL Solar Panel for Wireless Valve Link Systems
Components
- Solar Panel
- 40′ (12 m) Cable and WVL Solar End Cap Connection
- Solar Panel Ball Mount
- Wall-Mount Hardware
Installing the Solar Panel
- Remove the lock nut, end cap, and 9 V batteries from the existing Wireless Valve Link.
- Feed the entire bundle of Solar Panel wire through the end cap lock nut.
- Plug cable into connector within Wireless Valve Link battery compartment.
- Install the Solar Panel end cap in the Wireless Valve Link body and tighten the lock nut to secure it in place.
- Feed the red and black wires up through the Solar Panel ball mount.
- Install the ball mount where the Solar Panel will be located using one of the following methods
- Use the four included screws and anchors for drilling into a wall or flat surface.
- Use hose clamps or zip ties to attach to any round surface (e.g., pole, post, stake, pipe).
Open the Solar Panel cover and attach the Solar Panel over the ball mount. Make sure the red and black wires are coming through the ball mount into the Solar Panel housing and have enough slack to reach the (+) and (–) terminals. Position the Solar Panel in the desired location and tighten the three screws around the ball mount to secure it in place. Feed the wires through the waterproof grommet and attach the red wire from the cable to the red (+) terminal screw and the black wire to the black (–) terminal screw.
Ensure the rechargeable battery pack within the Solar Panel is installed and connected properly. Close the Solar Panel cover and tighten the screw to seal the housing
WVL App Setup
When using the Solar Panel with a Wireless Valve Link, use the Bluetooth® enabled Hunter Wireless Valve Link App to designate the Wireless Valve Link as “Solar Powered.”
- Open the Wireless Valve Link App and connect to the Wireless Valve Output Module (WVOM).
- Select the WVL menu.
- Toggle the Solar Powered switch to an active state when editing an existing or adding a new Wireless Valve Link.
- The Dashboard Details menu will indicate battery health with a solar icon for all Wireless Valve Links powered by solar.
Notices
Batteries should be recycled or disposed of separately from household waste
and according to local environmental laws and guidelines
Support
Scan to access helpful information about your product, including installation
tips, controller programming, and more. Helping our customers succeed is what
drives us. While our passion for innovation and engineering is built into
everything we do, it is our commitment to exceptional support that we hope
will keep you in the Hunter family of customers for years to come. Denise
Mullikin, President, Landscape Irrigation and Outdoor Lighting The Bluetooth®
word mark and logos are registered trademarks owned by Bluetooth SIG Inc. and
any use of such marks by Hunter Industries is under license © 2023 Hunter
Industries Inc. Hunter, the Hunter logo, and other marks are trademarks of
Hunter Industries Inc., registered in the U.S. and certain other countries.
UNTER INDUSTRIES | Built on Innovation®
1940 Diamond Street, San Marcos, CA 92078 USA
hunterindustries.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>