SIGNATURE HARDWARE 948975 Single Handle Pressure Balancing Valve Trim in Chrome Instruction Manual

SIMPLE SELECT
PRESSURE BALANCE VALVE TRIM
SKU: 948975, 948977, 948976, 948974, 948973, 948978

BEFORE YOU BEGIN

We recommend consulting a professional if you are unfamiliar with installing plumbing fixtures. Signature Hardware accepts no liability for any damage to the plumbing, tub, floor, or for personal injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the valve for shipping damage.
If any damage is found, contact our Customer Relations team at 1-855-715-1800.

GETTING STARTED

Ensure that you have gathered all the required materials that are needed for the installation.

TOOLS AND MATERIALS:

INSTALLATION

1. Unscrew the screws and remove the plaster guard.

2. Secure backplate (2) to the valve body (3) with the screws (1) using Allen wrench provided.

3. With the Allen wrench (1) provided, turn the adjusting bolts (2) clockwise until it connects to the diverter cartridges (3) and compresses to the limit position. Do not torque too much to prevent any damage.
   Note: Ensure that the adjusting bolts are tightened correctly to the limit position. Over-tightening may cause improper function of the diverter after installation.

4. Loosen the stop plugs (1) with wrench and place the stop valves (1) onto the holes in the bottom of the backplate.

5. Holding escutcheon (2) in place, tighten mounting nut (3) onto the backplate (1).

6. Water test:
   Turn on water lines. Press button 1 and 2 allowing water to flow from outlets. If the issues occur, go back to step 3 and re-install. (Before reinstalling, be sure to turn the adjusting bolts counterclockwise to the minimum position and put the stop plugs in original position.)
   Issue a: Button cannot bounce smoothly. (The adjusting bolts in step 3 cannot rotate to the limit position.)
   Issue b: There is no flow from outlets or button cannot be switched. (The adjusting bolts in step 3 is too tight.)

7. Install the handle (1) into backplate and secure with set screw (2). Cover with index (3).

REVISED 07/07/2021
CODES: SHPR8040, SHVL8040, SHPT8040, SHHB8040, SHGF8040, SHPC8040LH
customer service: 1.855.715.1800
signaturehardware.com

Documents / Resources

| SIGNATURE HARDWARE 948975 Single Handle Pressure Balancing Valve Trim in Chrome [pdf] Instruction Manual
948975, 948977, 948976, 948974, 948973, 948978, 948975 Single Handle Pressure Balancing Valve Trim in Chrome, 948975, Single Handle Pressure Balancing Valve Trim in Chrome, Pressure Balancing Valve Trim in Chrome, Balancing Valve Trim in Chrome, Valve Trim in Chrome, Trim in Chrome, Chrome
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>