Tera EV-Holder-SL EV Charger Cable Holder User Manual
- June 14, 2024
- Tera
Table of Contents
Tera EV Charger Cable Holder
User Manual
EV-Holder-SL EV Charger Cable Holder
| 
| 
---|---|---
1. Position the cable holder’s base flat against the wall in the desired
location, and mark the positions of the screw holes.| 2. Drill a hole with a
diameter of Φ 6mm at the marked position, ensuring it is at least 40mm deep.|
3. Insert plastic plugs vertically into the wall until they are flush with
the wall’s surface.
| 
| 
4. Align the cable holder’s hole with the wall plugs and securely fasten it by screwing in three K screws until they are fully tightened.
|
5. Provide a cross-sectional view demonstrating the screws fully tightened, ensuring the gun holder is securely fastened without any bending.
|
6. Assemble the front and base sections of the gun holder, then use C screws to securely fasten them in the indicated holes.
| No. | Material | Spec | Qty. |
|---|---|---|---|
| 1 | C screws | Use stainless steel deep-threaded tapping screws with a PB3.0*6mm | |
| Philips round head and flat tail | 2 | ||
| 2 | K screws | PWA3.5308mm/philips round head pointed tail stainless steel | |
| deep threaded tapping screws with pad | 3 | ||
| 3 | Plastic threaded plugs | M6*30MM, green or blue plugs | 3 |
| cs@tera-innovation.com
---|---
| +1 (626)438-1404 / +1 (909)242-8669
| +1 (626)438-1404
| https://tera-innovation.com/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>