RETEYUNG AJ221 Phone Stand Wireless Speaker User Manual
- September 6, 2024
- RETEYUNG
Table of Contents
RETEYUNG AJ221 Phone Stand Wireless Speaker User Manual
Please read carefully before use
Product Information
- Mobile phone stents，small and portable， easy to store
- Colorful atmosphere light，5 kinds of light effects with the music rhythm flashing
- Wireless speaker
- Hands-free calling
- More portable for outdoor to use with built-in high-capacity rechargeable lithium battery
- Low battery warning，power off after three times
Technical Parameters
| Wireless Version | V5.1 | Distortion Rate | ≤10% |
|---|---|---|---|
| Wireless Name | AJ221 | Output Power | 5W |
| Transmission Distance | ≥10m | SNR | 80dB |
| Frequency Response | 80Hz-20kHz | Color Light | 1W |
| Horn Parameters | Φ40mm4Ω5W | Power Supply | 5V 0.8A |
| Product Size | 131x80x43mm | Battery Capacity | 1800mAh |
Answer The Telephone
- When the phone is connected to the wireless speaker, you can double press the button to reject the call when there is an incoming call.
- When there is an incoming call, short press button to answer it. After the call is over, short press button to end the call.
- Double press button to dial the last call.
Speaker Operation
-
Long press button to turn on speaker and with a beep.
Search Bluetooth name“AJ221”on the phone.After the connection is successful，there will be a beep. -
Long press button to switch to the previous song short press to lower the volume.
-
Long press button to next song short press to increase the volume.When the volume reaches the maximum，there will be a beep.
-
Hold down the and button at the same time to cancel pairing with your phone.
-
Short press button to pause or resume playing,long press to turn off speaker and light.
-
Long press button to turn on the light short press to switch other light mode long press to turn off the light.
Charging Instruction
Plug the Type-C cable into the USB port for charging,the red light will be on when charging,and it will go out when fully charged.
Attention
- Please don’t charge the speaker under the temperature of 0°C-40 C.
- Not recommended for charging while using.
- Please pull out the USB cable after a full charge.
- Please don’t charge the speaker in high-humidity situation.
Support development
Warranty Card
Applicable for
-
Since buying date, the user enjoys one year free repair services under normal use. After one year,will be charged according to each component part cost.
In case change component part, will be charged according to our company’s component part cost list.
The following situations without free repair services in warranty period- Damage caused by natural earthquake, rat disaster, and abnormal use.
- Damage caused in transportation, fall, and improper storage.
- Consumable component, such as spare parts, batteries, light bulbs,etc.
- Warranty information records is not complete, no purchase date, no buying shop seal,etc.
- Featured using environment, such as humidity, sulphur area, high salty and on board,etc,easy corrosion area.
- Using not according to the instructions.
- Products sold by special agreement.
-
When return to factory for repair, the user should make sure the product packed property to avoid any damage during transportation.
-
Factory not responsible for the damages caused by the users themselves improper disassemble.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Not applicable
RF Exposure Information
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment can be used as portable exposure without any restriction.