EIZO S2134 Color LCD Monitor User Manual

: June 14, 2024
: EIZO

Table of Contents

S2134 Color LCD Monitor
Information for Radio Interference
Declaration of compliance with India RoHS
ENERGY STAR®
LIMITED WARRANTY
Product Information Sheet
Documents / Resources

User’s Manual – Setup Guide
FlexScan’ S2134
Color LCD Monitor

S2134 Color LCD Monitor

Important

Please read PRECAUTIONS, this Setup Guide and the User’s Manual carefully to familiarize yourself with safe and effective usage. Please retain this guide forfuture reference EIZO S2134 Color LCD Monitor - USB EIZO S2134
Color LCD Monitor - USB cable EIZO
S2134 Color LCD Monitor - monitor *Forthe latest product information including the User’s Manual’, refer to our web site**

Regulatory Compliance Notice

Information for Radio Interference

For U.S.A., Canada Only
FCC Supplier’s Declaration of Conformity

We, the Responsible Party	EIZO Inc.

5710 Warland Drive, Cypress, CA 90630
Phone: 562-431-5011
declare that the product| Trade name: EIZO
Model: FlexScan $2134

is in conformity with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does
cause harmful interference to radio o television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note
Use the attached specified cable below or EIZO signal cable with this monitor so as to keep interference within the limits of a Class B digital device.

ACCord
Shielded signal cable (enclosd)

Canadian Notice

This Class B information technology equipment complies with Canadian ICES-003.
The required text can be found in the “Information” menu of the product. For details, refer to the User’s Manual

Declaration of compliance with India RoHS

We, EIZO Corporation, hereby declare and guarantee that this product has been designed and manufactured in compliance with the E-Waste management rule which prohibit the inclusion of the following substances except for the exemptions listed in schedule

Lead, Mercury, Hexavalent Chromium, Polybrominated Biphenyls or Polybrominated Diphenyl Ethers exceeding a concentration of 0.1% by weight in homogeneous materials
Cadmium exceeding a concentration of 0.01% by weight in homogeneous materials For information on proper disposal and recycling of the product, please refer to the following website. wwuw.eizoglobal.comi/ewaste-in/

ENERGY STAR®

As an ENERGY STAR Partner, EIZO Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency.
Power consumption may increase depending on product settings and connection conditions

LIMITED WARRANTY

EIZO Corporation (hereinafter referred to as “EIZO”) and distrbutors authorized by EIZO (hereinafier referred to as the “Distibutors”) warrant, subject to and in accordance with the terms of this limited warranty (hereinatter referred to as the ‘Warranty”),to the original purchaser (hereinafter referredto as the “Original Purchaser’) who purchased the product specified in this document (hereinafter referred to as the “Product’) from EIZO or Distrbutors, that EIZO and Distrbutors shall, at their sole discretion, either repair or replace the Product at no charge if the Original Purchaser becomes aware within the Warranty Period (defined below) that the Product malfunctions oris damaged in the course of normal use of the Product in accordance with the description in the instruction manual of the Product (hereinafter referred to as the “User’s Manua).

The period of this Warranty is five (5) years from the date of purchase of the Product or 30,000 hours of usage time, whichever comes earfier (hereinafter referred to as the ‘Warranty Period”). EIZO and Distributors shall bear noliabilty or oblgation with regard to the Product in relation to the Original Purchaser or any third parties other than as provided under this Warrarty.
EIZO and Distributors will cease to hold or store any parts (excluding design parts) of the Product upon expiration of five (5) years after the production of the Product s discontinued. In repairing the Product, EIZO and Distributors wil use renewal parts which comply with our QC standards. ff the unit cannot be repaired due to ts condiion or the stockout of a relevant part, EIZO and Distrbutors may offer the replacement by a product with equivalent performance instead of repairing iThe Warranty is vald only in the countries o territories where the Distributors are located. The Warranty does not restrict any legal rights of the Original Purchaser.
Notwithstanding any other provision of this Warranty, EIZO and Distributors shall have no obligation under this Warranty whatsoever in any of the cases as set forth below:

(a) Any defect of the Product caused by freight damage, modification, akeration, abuse, misuse, accident, incorrect installation, disaster, adherent dust, faulty maintenance andor improper repair by third party other than EIZO and Distibutors;
(b) Any incompatbilty of the Product due to possible techinical innovations andor regulations;
(c) Any deterioration of the sensor, including measurement value of the sensor;
(d) Any defect of the Product caused by extemal equipments;
(e) Any defect of the Product caused by the use under environmental conditions not antcipated by EIZO;
(f) Any deterioration of the ttachments of the Product (e.g. cables, User’s Manual, CD-ROM, etc ).
(g)Any deterioration of the consumables, and/or accessories of the Product (e.g. batteries, remote controller, touch pen, etc. );
(h) Any exterior deterioration or discoloration of the Product, including that of the surface of the LCD panel, the touch panel and the protect panel;
(i) Any defect of the Product caused by placement in a location where it may be affected by strong vibrations or shocks:
(j) Any defect of the Product caused by leaking battery liquid;
(k) Any deterioration of display performance caused by the deterioration of expendable parts such as the LCD panel and/or backlight, etc. (eg. changes in brightness, changes in brightness uniformity, changes in color, changes in color uniforrmity, defects in pixels including burnt pixels, etc.);
(l) Any deterioration or malfunction of the cooling fan caused by adherent dust.

To obtain service under the Warranty, the Original Purchaser must deliver the Product, freight prepaid, in is original package or other ‘adequate package affording an equal degree of protection, assuming the isk of damage andior loss in transit to the local Distribuor.
‘The Original Purchaser must present proof of purchase of the Product and the date of such purchase when requesting services under the Warranty.
The Warranty Period for any replaced andior repaired product under this Warranty shall expire at the end of the original Warranty Period EIZO OR DISTRIBUTORS ARE NOT RESPONSIBLE FOR ANY DAMAGE TO, OR LOSS OF, DATA OR OTHER INFORMATION STORED IN ANY MEDIA OR ANY PART OF ANY PRODUCT RETURNED TO EIZO OR DISTRIBUTORS FOR REPAIR.
EIZOAND DISTRIBUTORS MAKE NO FURTHER WARRANTIES, EXPRESSED OR IMPLIED, WITH RESPECT TO, INCLUDING, WITHOUT LIMITATION, THE PRODUCT AND TS QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FORANY PARTICULAR USE.
INNO EVENT SHALL EIZO OR DISTRIBUTORS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, CONSEQUENTIAL OR OTHER DAMAGE WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFIT, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THE PRODUCT OR IN ANY CONNECTION WITH THE PRODUCT, WHETHER BASED ON CONTRACT, ‘TORT, NEGLIGENCE, STRICT LIABILITY OR OTHERWISE, EVEN IF EIZO OR DISTRIBUTORS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
THIS EXCLUSION ALSO INCLUDES ANY LIABILITY WHICH MAY ARISE OUT OF THIRD PARTY CLAIMS AGAINST THE ORIGINAL PURCHASER. THE ESSENCE OF THIS PROVISION IS TO LIIT THE POTENTIAL LIABILITY OF EIZO AND DISTRIBUTORS ARISING OUT OF THIS LIMITED WARRANTY AND/OR SALES.

Product Information Sheet

COMMISSION DELEGATED REGULATION (EU) 2019/2013 with regard to energy labelling of electronic displays

| Parameter| Parameter or value and precision| Unit
---|---|---|---
1.| Supplier’s name or trademark| EIZO|
| Supplier’s address| EIZO Europe GmbH, Belgrader Stralle 2, 41069 MOnchengladbach, Germany|
2.| Model identifier| FlexScan S2134|
3.| Energy efficiency class for Standard Dynamic Range (SDR)| C|
4.| On mode power demand in SDR| 10.0| W
5.| Energy efficiency class for High Dynamic Range (HDR)| n.a.|
6.| On mode power demand in HDR, if implemented| n.a.| W
7.| Off mode, power demand, if applicable| 0.3| W
8.| Standby mode power demand, if applicable| 0.5| W
9.| Networked standby mode power demand, if applicable| n.a.| W
10.| Electronic display category| Monitor|
11.| Size ratio| 4:03|
12.| Screen resolution| 1600 x 1200| pixels
13.| Screen diagonal| 54.0| cm
14.| Screen diagonal| 21| inches
15.| Visible screen area| 14.0| dm2
16.| Panel technology used| LCD|
17.| Automatic Brightness Control (ABC) available| Yes|
18.| Voice recognition sensor available| No|
19.| Room presence sensor available| No|
20.| Image refresh frequency rate (default)| 60| Hz
21.| Minimum guaranteed availability of software and firmware updates (from the date of end of the placement on the market)| 5| Years
22.| Minimum guaranteed availability of spare parts (from the date of end of the placement on the market)| 5| Years
23.| Minimum guaranteed product support| 5| Years
| Minimum duration of the general guarantee offered by the| 5| Years
24.| Power supply type| Internal|
25.| External power supply (non standardized and included in the product box)
i| |
ii| Input voltage| –| V
iii| Output voltage| –| V
26.| External standardised suitable power supply (if not included in the product box)
i| |
ii| Required output voltage| –| V
iii| Required delivered current (minimum)| –| A
_ iv| Required current frequency| –| Hz