Tribit IC-BTS30 StormBox 24W Portable Bluetooth Speakers User Manual
- June 14, 2024
- Tribit
Table of Contents
PORTABLE WIRELESS SPEAKER STORMBOX
1C-BTS30
USER MANUAL
Safety Precautions
- Avoid dropping the speaker on the floor.
- Do not try to disassemble or repair the speaker unless you are a technician.
- Never expose the speaker to extreme high or low temperatures.
- Stop use immediately if thunderstorm happens.
- Do not clean its surface with any corrosive cleanser or other chemical solutions.
Specifications
- Bluetooth version: V4.2
- Bluetooth profile: A2DP, AVRCP, HFP, HSP
- Driver: 2x ®45mm, 2 x Passive radiator
- Output power: 2 x 12W
- Signal-to-noise ratio = 80dB
- Frequency response: 70-20KHz
- Frequency band: 2.402GHz~2.480GHz
- Maximum transmission power: = 20dBm
- Battery: 7.4V,2600mAh,19.24Wh
- Music play time: Up to 20 hours (varies by volumelevel and music files)
- Charging time: 4 hours @ DC 5V/2A
- Dimensions: 68x180x68mm/2.68×7.09×2.68 in
- Weight: 580g/20.40z
What’s in the Box
Overview Buttons & Indicators
Connections
Wireless Party Mode with Two StormBox
Step 1: Connect the Speaker A and B
- Keep Speaker A and B power on
- Press the Bluetooth button on Speaker A at least Ss till the tone comes up
- Wait for the Speaker A and B connecting success with tone
Step2: Pair/Connect the Speaker A
Note: Same as normal Bluetooth pairing
Step3: Enjoy music with two StormBox
Buttons
| Function | Button | Operation |
|---|---|---|
| Power ON/OFF | Power Button | Press the button to turn on/off the speaker |
| Pair a Bluetooth Device | Bluetooth Button | Press the button to manually enter |
pairing mode
Volume Up| Volume +| Press the button to increase the volume level
Volume Down| Volume –| Press the button to decrease the volume level
Play/pause| MFB| Press once the button
Next track| MFB| Double press the button
Previous track| MFB| Press the button for 3 times
answer/end the incoming call| MFB| Press once the button
Reject an incoming call| MFB| Press and hold the button for 2s
Voice dial function| MFB| Press and hold the button for 2s to activate (your
device must support this function)
XBASS| XBASS| Press the button to switch Bass and normal mode
Indicators
| Indicator | Status |
|---|---|
| Power indicator | Blue indicator flashes slowly |
| Blue indicator flashes quickly | Bluetooth pairing mode |
| Blue indicator keeps sturdily on | Connected |
| XBASS indicator | White indicator lights up |
| Battery indicator | Four white indicators light up |
70% — 100%
Three white indicators light up| Remaining battery
power: 50%∼70%
Two white indicators light up| Remaining battery
power: 30% ∼50%
One white indicator lights up| Remaining battery
power: 10% ∼30%
A red indicator lights up| Low battery power (<10%), Please recharge the
speaker
Reset
If this speaker has any problem, you can try to press and hold Volume + and
Volume – buttons simultaneously for 5s to reset this speaker and remove the
old pairing in your Bluetooth device, and then pair again.
Customer Service
- 18-month limited warranty
- For FAQS and more information, please visit: Email: support@tribit.com
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class 8
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Caution
‘This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>