Ledvion LV10001 LED Dimmer Switch Instruction Manual
- June 14, 2024
- Ledvion
Table of Contents
LED DIMMER
Manual for LED dimmer switch
LV10001_1
5692 DH Son en
Breugel
Ekkersrijt 4304
The Netherlands
www.ledvion.com
INSTALLATION:
- Make sure the electricity is switched off before any operation, connect the wire as shown in the “wire connection”.
- Install the dimmer into the junction box
- Switch on electricity, push shaft button to ON or OFF, turn the shaft to dimming brightness. When lamps are flashing, adjust the min setting to the minimum brightness level, make lamps stable
- When all settings are finished, you can fit the dimmer in the wall. Cover the frame and the dimmer knob on the dimmer.
“If the dimmer is overloaded and gets too hot, the dimmer will start the protection function, so the dimmer will stop working. When you solve the issue, 5 minutes later push the rotary to reset the dimmer, dimmer will then work well again
WIRING CONNECTION:
MIN. BRIGHTNESS SETTING
To set the min. brightness to avoid flickering or satisfied min brightness:
- Ensure the lamp module is switched ON
- Anti-clockwise the Knob
- Clockwise the VR – Variable Resister
- Anti-clockwise the VR to decrease the brightness at the min. & max. point
| **** | This device is in compliance with EN 60669-2-1. |
|---|---|
| Should not be disposed with other household wastes, | |
| This product is not a toy. Keep away from children and animals. | |
| Do not expose this product to moisture, water or other liquids. | |
| Do not attempt to examine or repair this product yourself. | |
| This product is designed for indoor use only. Do not use outside! |
LEDVION DIMMER:
This RC dimmer has been developed specially for dimmable LED lamps.
Addionally, the minimum brightness setting of the dimmer can be adjusted to
achieve the optimum dimming range for a particular load. You may need to refer
to these instructions if you change your lights to a different type at a later
date so please keep them for reference.
TECHNICAL DATA:
| Operating Voltage | 220-240V – |
|---|---|
| Frequency | 50HzE |
| Max. fight sources | 20• (multiple LEDs possible per driver) |
| Max. number of LED drivers | 20• |
| Maximum load | 300WNA/ Pf a 0.90 |
| Minimum load | 10W |
| Dimming mode | Trailing edge/ PC |
| Control method | 1Wo way |
| Ambient temperature | <60°C (T amb = 60°C) |
| Dimmable LED lamps | 5 -150W/VA |
- NOTE: When usi igh quality LED low intush currents
WARNING!
Certain light sources may not behave according to their power rating when used with a dimmer. An overload will result in the safety feature switching the dimmer off. We always recommend to connect under the suggest load.
5692 DH Son en Breugel
Ekkersrijt 4304
The Netherlands
www.ledvion.com
Documents / Resources
|
Ledvion LV10001 LED Dimmer
Switch
[pdf] Instruction Manual
LV10001 LED Dimmer Switch, LV10001, LED Dimmer Switch, Dimmer Switch, Switch
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>