nVent HOFFMAN CEL550 Compact Enclosure Light Instruction Manual
- June 14, 2024
- nVent HOFFMAN
Table of Contents
Compact Enclosure Light CEL550, CEL550M
Luminario LED
Rev. B © 2021 Hoffman Enclosures Inc. PH 763 422 2211 • nVent.com/HOFFMAN 89217033
Safety Instructions
Read this short manual carefully and keep it accessible for further reference!
Safety instructions
Disregard of the safety instructions may lead to danger of life, burning or fire!
- Installation, mounting or works on the electrical connection may only be carried out by an approved electrician.
- For installation, the valid regualtions of the country where the luminaire is installed and operated have to be noticed as well as their national regulation of accident prevention.
- The product may not be modified or converted.
- The luminaire may not be operated in direct contact to water, aggressive materials or inflammable gases and vapours.
- Do not hang or fasten anything on the product, especially no decoration.
- The environment may correspond to a maximum pollution degree of 2.
- Do not cover the product – provide free air circulation.
- If an error occurs, you may NOT touch the product or operate it further. Turn off the product on the external light switch or by disconnecting the cable at the fuse immediately. In case of contact and continued operation while malfunction there is life hazard by fatal electric shock, burn hazard or fire hazard!
A malfunction exists when:
- visible damages appear.
- the product does not work properly (e.g. flickering).
- smoke, steam or crackling sounds appear.
- smell of burning is recognisable.
- an overheating is recognisable (e.g. by discolouration of adjacent surfaces).
Operate the product only after maintenance and examination by an approved electrician!
Additional safety instructions are indicated by this symbol:
Appropriate use
This product serves only for lighting purposes and may:
-
only be mounted in suitable control cabinets.
-
only be operated when firmly mounted on a stable, even and tilt-fixed surface.
-
not be mounted on easily inflammable surfaces.
-
only be used in dry condition,
– not in damp or dirt-endangered rooms.
– not in areas of high air humidity. -
not be exposed to strong mechanical loads or to strong contamination.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Maintenance and Care
Maintenance
- The product is maintenance free.
- If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord exclusively available from the manufacturer or his service agent.
Care
Disconnect the product from the power supply and let it cool down, before you
clean the product.
-
Clean the product on a regular basis using a slightly water moistened, soft and flufffree cloth. Please also note additional supplied notes on maintenance and care.
-
-
Storage and Disposal
Storage
- The product must be stored in a dry and clean environment. Do not strain the product mechanically during storage.
After a damp or soiling storage the product may only be installed after checking its condition by an approved electrician.
Disposal (European Union)
-
Do not dispose the product with the regular household waste! Products marked with this sign must be disposed according EU-directive 2012/19/EU devices at local collection points for such devices!
-
-
Installation
Installation instructions (read completely before installation)
Switch off the mains or respectively the connection lead before doing any
works!
Only use parts, which are supplied with the product or are described as
accessories! Inspect the product for loose parts inside the housing!
When there are loose parts inside the housing and these are not explicitly
described, the product may not be installed or operated!
Only use fastening material suiting the installation background!
Unpacking
- Check the delivery for completeness.
- Carefully take the product out of the packaging and remove any transport safeguards.
- Before disposal of the packaging material make sure that all components of the product are removed.
- Dispose of the packing material professionally.
- Keep the packing material away from children.
Installation steps
- Install the LED-luminaire as shown in the figures [1] – [3].
- Depending on the installation situation, the holders can be interchanged. Figures [4] – [5]
Electrical Connection
- Connect the power supply to the luminaire as shown in figure [6].
- When connecting several luminaires in feed-through wiring, connect them as shown in figure [7].
Max. number of lamps in feed-through wiring: 4
- Unlock the power supply as shown in figure [8] if needed.
- When inserting and removing a plug, hold the light with one hand!
- Use Copper Conductors Only. A suitable branch circuit protective device shall be provided upstream, in USA / Canada max. 15A.
Check if the product functions properly and is securely fixed!
Product Overview
- Motion detector (PIR);
- LED – Optics;
- Power input;
- Power output;
- plug unlocking;
- ON/OFF switch;
Installation
1 Option
2a Option
2b
3 Option
Channel mounting
4a
4b
5
Electrical Connection
6a
6b
7
max. 4
8a
8b
Operation
- Art.-No.:CELxxxM
- Condition of delivery
- Optional mode
- Art.-No.:CELxxx
- Condition of delivery
- Optional mode
Accessories
| |
Length
|
Version
|
Order number
---|---|---|---|---
orange|
black noir
I.| Connection cable|
3 m
| CE| CELC3001 PO|
CELC3001PB
CE/UL
| –|
CELC3001PBUL
II.| Through wiring cable|
1 m
| CE| CELC1001TO|
CELC1001TB
CE/UL
| –|
CELC1001TBUL
III.| Connectors|
–
| ALL|
CELCN1
IV.| Magnet mounting kit|
–
| ALL|
CELAO2MF
Technical Data
Art.-No.:|
CEL550
|
CEL550M
---|---|---
Rated Power|
5,1 W
Nominal voltage|
24 V – 240 V DC or AC 50-60 Hz
Rated current|
190 mA ( 24 V = )
30 mA ( 230 V ~ )
45 mA ( 120 V ~ )
Power factor|
0,6
Degree of protection|
IP 20
Protection class|
II
Light color|
Typ. 5300 K
Color rendering|
80
Luminous flux|
550 Im
LED life|
50000 h
Photobiological safety|
Gruppe 0
Label homologation|
CE / ENEC, UKCA, cURus
Safety standard|
IEC Standards
|
UL Standards
EN 60598-1:2015/A1:2018 + EN 60598-2-1:1989
|
UL 508
Emission|
EN IEC 55015:2019 + A11:2020
|
FCC CFR 47 part 15 subpart B cl. B
Immunity|
EN 61547:2009 + EN 60669-2-1:2004 + A1:2009 + Al2:2010
|
Operating temperature|
-20°C … +55°C
Storage temperature|
-40°C … +60°C
Rel. Humidity|
5-85 %
Dimensions (LxWxH)|
396 mm x 32 mm x 40 mm
Weight|
180 gr
This luminaire contains a light source of energy efficiency class D.
Importador: Hoffman EnclosuresMéxico S de RL de CV
Dirección: Av. Industrial Falcon Lote 7 A Sin NúmeroCP.
88736 Reynosa Tamaulipas México
Tel: 889 909 4220
© 2021 nVent www.nvent.com
nVent
2100 Hoffman Way
Anoka, MN 55303-1745
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>