INDESIT S6230P Top Loading Washin Instructions

June 14, 2024
INDESIT

INDESIT logo S6230P Top Loading Washin
Instructions

S6230P Top Loading Washin

INDESIT S6230P Top Loading Washin - FigINDESIT
S6230P Top Loading Washin - Fig 1

SAFETY RULES

Before using the appliance, read the following safety regulations. Keep them for any subsequent consultations.
This manual and the appliance are accompanied by important safety warnings, which must be read and always wait for you. !The manufacturer disclaims any liability arising from failure to comply of these safety instructions, by uses of the appliance or incorrect settings of commands.
Keep children under 3 years of age away from the appliance. Without the constant surveillance of an adult, keep the appliance out of reach of children under 8 years of age. The use of this appliance by older children over 8 years old, of people with reduced mobility physical, sensory or mental capabilities or people without adequate experience and knowledge permitted only with adequate supervision, or if such persons have been trained in safe use of the appliance and are aware of the risks.
Do not allow children to play with the appliance. Cleaning and maintenance routine should not be performed by children without adult supervision.
Do not force the door open.
ALLOWED USE & ATTENTION: The appliance is not intended for be operated using a device external switching device, for example a timer, or through a system of separate remote control.
The appliance is intended for domestic and commercial use similar applications, such as: kitchen areas for staff in shops, offices and other working environments; farmhouses; hotel rooms, motels, bed & breakfasts and other residential environments; areas of common use in condominiums or laundromats.
Do not charge the appliance beyond its capacity maximum (kg of dry laundry) indicated in program table.
This appliance is not intended for use professional. Do not use the appliance outdoors.
Do not use solvents (e.g. turpentine, benzene), detergents containing solvents, powders abrasives, glass or general cleaners or liquids flammable; do not machine wash treated fabrics with solvents or flammable liquids.

INSTALLATION

To avoid the risk of personal injury, the appliance must be moved and installed by two or more people. Pearls operations Unpacking and installation use gloves protective gear to avoid cuts.
IMPORTANT: TO READ AND OBSERVE
Do not move the washing machine by holding it by the surface oil top panel.
  Installation, including any water supply fittings and connections electrical, and repair work must be carried out by qualified personnel. Not repair or replace any part of the appliance, unless specified in the user manual.
Keep children away from the site of the installation. After unpacking the appliance, make sure it has not been damaged during transportation. in case of problems, contact your dealer or Service Assistance. Once installation is complete, store the packaging material (plastic parts, polystyrene, etc.) out of the reach of children avoid the risk of suffocation. To avoid risks of electric shock, before proceeding When installing, disconnect the appliance from the mains electric. During installation, make sure that the appliance cannot damage the cable power supply and thus cause shock risks electrical. Only activate the appliance after having completed the installation procedure.
Do not install the appliance in an exposed room to extreme conditions, in particular to ventilation inadequate or at temperatures below 5°C or above 35°C.
During installation, check that the four feet are well supported and stable on the floor, adjust them if necessary, and check that the appliance is perfectly level using a spirit level.
If the appliance is to be installed on a wooden or “floating” floor (parquet or laminate), fix a panel of plywood (at least) 60 x 60 x 3 cm from use as a support base for the appliance.
Connect the water inlet hose in accordance with the regulations in force.
For models with AC power only cold water: do not connect to the pipe of hot water.
For models with hot water supply: the hot water inlet temperature does not must exceed 60 °C.
The washing machine @ is equipped with screws which prevent damage during transport. Before using it @ necessary remove the transport bracket (see “Installation instructions”). Then cover the openings with the two caps supplied. To remove the lower protection by tilting and rotating the washing machine on one of the rear corners. Check than the plastic part of the lower protection (if present in the purchased model) remains in the packaging and not on the bottom of the appliance.
This @ important, because differently the plastic part could damage the washing machine during operation.
  After installing the appliance, wait a few hours before starting it so that it adapts to the local conditions.
  Check that the ventilation holes located in the washing machine plinth (if present) are not present obstructed by carpets or other materials.
Use only new hoses to connect the appliance to the water supply. | old pipes not must be reused.
The water delivery pressure must be of 0.1-1 MPa.

ELECTRICAL WARNINGS

It must be possible to disconnect the appliance from the mains by unplugging the plug, if any is accessible, or via a multi-pole switch installed upstream of the socket in compliance with the current electrical regulations; also, the appliance must be earthed in accordance with the regulations national electrical safety standards.
Do not use extension cords, multiple sockets or adapters. Once the installation is complete, i electrical components should no longer be accessible to the user. Do not use the appliance when you are wet or on foot naked. Do not turn on the appliance if the cable power supply or plug is damaged, if so they observe operating anomalies or if the appliance has been dropped or damaged.
If the power cord is damaged, it must be replaced with one of the same type from manufacturer, by an authorized service center or by a qualified technician to avoid situations of danger or risk of electric shock.

CLEANING AND MAINTENANCE

WARNING: To avoid the risk of electric shock, before any maintenance intervention make sure the appliance is turned off and unplugged from the electrical supply; also, do not use in no steam jet cleaners.

DISPOSAL OF MATERIAL PACKAGING

The packaging material is 100% recyclable and is marked with the recycling symbol **.
The various parts of the packaging must therefore be disposed of responsibly and in strict compliance with the rules established by local authorities.
DISPOSAL OF HOUSEHOLD APPLIANCES
This product was manufactured with recyclable material or usable, Dispose of the product in compliance with local regulations in the field. For more information on treatment, recovery and recycling of household appliances, contact your local office responsible, the household waste collection service or the shop where the product was purchased. This appliance is & marked in accordance with the European Directive 2012/19/EU on waste electrical and electronic equipment (WEEE).
By ensuring this product is disposed of correctly, user helps prevent negative consequences for environment and health **
symbol 2 on the product or documentation accompanying indicates that this appliance must not be disposed of as household waste, but rather taken to a centre collection responsible for the collection of electrical and ed. equipment electronic.

INDESIT logo

Documents / Resources

| INDESIT S6230P Top Loading Washin [pdf] Instructions
S6230P Top Loading Washin, S6230P, Top Loading Washin, Loading Washin, Washin
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals