ANKER PowerCore 5000 Portable Power Bank User Guide
- June 14, 2024
- Anker
Table of Contents
Welcome Guide
PowerCore 5000
Using Your PowerCore
-
Check the power level
-
Charge your phone or tablet
*No Lightning cable
included. -
Recharge your PowerCore
When your PowerCore is fully charged, the LED indicators willturn of.
Important Safety Instructions
When using this product, basic precautions should always be followed, including the following:
- Store product in a cool and dry place.
- Do not store the product in hot or humid environments.
- Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or injury to persons.
- Operating temperature should be between 32°F / OC to 104°F / 40Cc.
- Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons.
- If the product is not used for long periods of time, you should change and discharge once every three months.
- When charging a device, the product may feel warm, this is a normal operating condition and should not be cause for concern.
- In normal conditions, the battery performance will decline over several years.
- Do not dispose of the product in heat or fire.
- Do not clean the product with harmful chemicals or detergents.
- Misuse, dropping, or excessive force may cause product damage.
- When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems separate from each other.
- Be aware discharged battery may cause fire or smoke, tape the terminals to insulate them.
**** This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1109 is
in compliance with Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at the following internet address: https://Awww.anker.com
Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3, 80807 Munich,
Germany
Anker Technology (UK) Limited | GNR8, 49 Clarendon Road,
Watford, Hertfordshire, WD17 1HP, United Kingdom
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1109 is
in compliance with following Directives: Electromagnetic Compatibility
Regulations 2016, The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012. The full text of the
UK declaration of conformity is available at the following internet address:
https://Awww.anker.com
Anker Technology (UK) Ltd I Suite B, Fairgate House, 205 Kings
Road, Tyseley, Birmingham, B11 2AA, United Kingdom
FCC Statement
This device complies with Part 15 of the FCC Rules, Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation,
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
The following importer is the responsible party:
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: 1-800-988-7973
IC Statement
This device complies with Industry Canada license-ICES-003.
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
To give your PowerCore the fastest, safest recharge, use an Anker® USB charger.
Specifications
| Cell Capacity | 5000 mAh /18.5 Wh |
|---|
Input| 5 V=2 A
Output| 5 V=2 A
Size| 108 x 33 x 33 mm
4.3 x 1.3 x 1.3 in
Weight| 134 g/ 4.7 oz
Attention
| Topreserve battery lifespan,use and recharge at least once every 4 months
---|---
| Do not disassemble
| Use original or certified cables
| Do not expose to liquids
| Avoid dropping
| Avoid extreme temperatures
Customer Service
18-month limited warranty
Lifetime technical support
1800-9887973 (US/CA)
PAP 22
Raccolta Carta
For FAQs and more information please visit:
| @Anker
@Anker Japan
@Anker Deutschland
---|---
| @AnkerOfficial
@Anker_JP
| @Anker
Product Number: A1109
51005001957 V04
Documents / Resources
|
ANKER PowerCore 5000 Portable Power
Bank
[pdf] User Guide
PowerCore 5000 Portable Power Bank, PowerCore 5000, Portable Power Bank, Power
Bank, Bank
---|---