HEMRORO B0C697HCMN Extra Wide Baby Gate for Doorways User Manual

June 14, 2024
HEMRORO

HEMRORO B0C697HCMN Extra Wide Baby Gate for Doorways

PARTS

PLEASE CHECK TO MAKE SURE YOU HAVE THE FOLLOWING PARTS

  • (A) Gate frame(1)

  • (B) Pressured Adjustment Bolts(4)

  • (C) Anchor

  • (D) Anti-kick Board

  • (E) 12cm Gate Extension

  • (F) 12cm Gate Extension

  • (G) 24cm Gate Extension

ASSEMBLY INSTRUCTIONS

Don’t cut off the tie before installation, or it will cause the doorway to deform as shown, which will increase the difficulty of installation. this is not a quality problem, the gate still can be installed

  1. Locate the 4 pressured Adjustment Bolts (B). Rotate the adjustment wheels along the threading, eliminating the gap between the adjustment wheel and the rubber foot.

  2. Insert the 4 Pressured Adjustment Bolts (B) into the holes at each of the four corners of the gate. Try to keep the left and right sides of the bolts symmetrical.

  3. Position the gate so that it is level and centered within your doorway or opening. Twist 4 adjusting nuts until the mark line on the lock tongue is parallel with the lock slot, then the installation is successful.

    USING THE LATCH

  4. Press your palm against the upper part of the plastic block at the same time, gently pull back the entire plastic parts to compress the headlock to open the door of the frame.

  5. Adding extension
    Choose the side of the gate to be extended and remove Pressured Adjustment Bolts.
    Insert all the extensions to the holes of the main gate. (if there are two or three extensions, you can put left side and right side each side one or two extensions, not put all the extensions in one side of the gate.) Insert the 4 spindle rods as instructed in Step 2. Reposition the gate in your doorway or opening and
    Add in anchor to the bottom to where the gate pieces join to stable the entire frame.
    Add the Anti-kick Board to the bottom of the main gate to avoid older and child fall down by the gate.

WARNING

  • To prevent serious injury or death securely install gate in doorway or opening according to instruction.
  • Check the gate regularly to see if all the hardware and mountings are tightened.
  • Never use with pet able to jump over or dislodge from opening. Never leave pet unattended.
  • Use only with the latch locked and securely engaged.
  • Stop using gate if any parts are missing or damaged.
  • This product will not prevent all accidents.
  • Strangulation hazard: Pets can force themselves into very small openings; use this gate with pets whose heads will not fit into openings in the gate, between the gate and floor, or between the gate and wall.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals