vtech ‎80-546800 Switch and Go Velociraptor Jet Instruction Manual

June 6, 2024
vtech

‎80-546800 Switch and Go Velociraptor Jet

Instruction Manual
®
VELOCIRAPTOR JET
91-004023-000 US CA

INTRODUCTION
Switch into fun with the Switch & Go® Velociraptor Jet. Transform this cool Jet into a ferocious Velociraptor and back in just a few simple steps. Launching propellers, flame effects and an animated LCD screen bring the action to life in your very own dino universe.

LCD Screen

Off/Low/High Volume Switch

Propeller Launcher

Voice Button

NOTE Do not aim propellers at face or eyes.

Projection Light Button
2

INCLUDED IN THE PACKAGE
· Switch & Go® Velociraptor Jet · 2 Propeller Discs · Quick Start Guide WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety. NOTE Please save this manual as it contains important information. ATTENTION Pour la sécurité de votre enfant, débarrassez-vous de tous les produits d’emballage tels que rubans adhésifs, feuilles de plastique, attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet. NOTE Il est conseillé de sauvegarder ce manuel car il comporte des informations importantes.
3

GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off. 2. Find the battery cover located on
the bottom of the unit and use a screwdriver to loosen the screw, then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AA (LR6/AM-3) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.) 5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation. Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte. Tenir les piles ou accumulateurs hors de portée des enfants.
4

IMPORTANT: BATTERY INFORMATION
· Insert batteries with the correct polarity (+ and -). · Do not mix old and new batteries. · Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries. · Only batteries of the same or equivalent type as recommended
are to be used. · Do not short-circuit the supply terminals. · Remove batteries during long periods of non-use. · Remove exhausted batteries from the toy. · Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
· Remove rechargeable batteries from the toy before charging. · Rechargeable batteries are only to be charged under adult
supervision. · Do not charge non-rechargeable batteries.
5

IMPORTANT : INFORMATIONS CONCERNANT LES PILES
Les piles fournies avec le produit permettent de tester le jouet en magasin mais ne sont pas des piles longue durée. · Mettre en place les piles ou les accumulateurs en respectant les
polarités + et ­. · Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés. · Ne pas mélanger différents types de piles : alcalines, zinc-
carbone et rechargeables. · Seules des piles du type recommandé doivent être utilisées. · Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le ­). · Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée. · Enlever les piles ou les accumulateurs usagés du jouet. · Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
· Enlever, lorsque c’est possible, les accumulateurs du jouet pour les recharger.
· Les accumulateurs ne doivent être chargés que sous la surveillance d’un adulte.
· Ne pas tenter de recharger des piles non rechargeables.
PRODUCT FEATURES
1. Off/Low/High Volume Switch To turn the unit On or adjust the volume, slide the switch to the Low or High volume position. To turn the unit Off, slide the switch to the Off position.
6

2. Projection Light Button Press the Projection Light Button and the unit will project a light pattern.
3. Voice Button Press the Voice Button to hear fun phrases and cool sounds.
4. Propeller Launcher Spin the propeller disc clockwise several times, and then press the Propeller Launcher. The propeller disc will fly out. Note: Do not aim at eyes or face.
5. LCD Screen The LCD Screen shows dino eye animations in Dino mode and shows pilot animations in Jet mode.
6. Automatic Shut-Off To preserve battery life, the unit will automatically shut off after approximately 20 seconds without input. The unit can be turned on again by pressing the Voice Button or Projection Light Button or by switching between Dino and Jet modes. The unit will also automatically turn off when battery power is very low.
7

TRANSFORMATION

1. Begin in Jet mode.

2. Flip out the Dino’s feet.

3. Flip down the Dino’s legs.

4. Move the Dino’s head down.

5. Flip down the Dino’s arms.

6. Flip up the Dino’s tail. The

NOTE

unit is now in Dino mode.

To switch the Dino back into a Jet, follow the above steps in reverse order. 8

CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat sources. 3. Remove the batteries if the unit will not be in use for an extended
period of time. 4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow these steps: 1. Turn the unit Off. 2. Interrupt the power supply by removing the batteries. 3. Let the unit stand for a few minutes, then replace the batteries. 4. Turn the unit On. The unit should now be ready to use again. 5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or visit our website vtechkids.com and fill out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.
9

NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
10

Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance Information

Trade Name:

VTech®

Model:

5468

Product Name:

Switch & Go® Velociraptor Jet

Responsible Party: VTech Electronics North America, LLC

Address:

1156 W. Shure Drive, Suite 200

Arlington Heights, IL 60004

Website:

vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAN ICES-003(B)/NMB-003(B)

11

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com vtechkids.ca
Read our complete warranty policy online at vtechkids.com/warranty vtechkids.ca/warranty
TM & © 2021 VTech Holdings Limited. All rights reserved. Printed in China.
91-004023-000 US CA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals