Enerlites YQTS220-I Commercial Grade Toggle Switch Instruction Manual
- June 14, 2024
- ENERLITES
Table of Contents
Enerlites YQTS220-I Commercial Grade Toggle Switch
Product Information
Specifications
- Switch Type: 4-Way
- Ground Screw: Green
- Ground Wire: Green or bare
- Common Screw: Black
- Common Wire: Black
- Neutral Screw: Yellow
- Neutral Wire: White
- Conductor Type: Copper
- Conductor Size: 20A, 10AWG to 12AWG
Product Usage Instructions
Important Safety Instructions
Please read and follow these safety instructions before installing the
switch:
- Installation should be performed by a qualified person in accordance with national and local electrical codes.
- To prevent electric shock or death, always disconnect the power before installing the switch.
- Use copper conductors only for proper electrical connection.
Installation Steps
Step 1: Power Off
- Before starting the installation process, make sure to turn off the power supply to the circuit where the switch will be installed.
- This step is crucial to ensure your safety.
Step 2: Wire Preparation
Gather the necessary wires for installation:
- Green or bare wire for ground
- Black wire for common
- White wire for neutral
Step 3: Connect Ground Wire
- Connect the ground wire to the green screw on the switch. Make sure it is securely tightened.
Step 4: Connect Common Wire
- Connect the black wire to the common screw on the switch. Ensure a tight connection.
Step 5: Connect Neutral Wire
- Connect the white wire to the yellow screw on the switch. Ensure a secure connection.
Step 6: Mount the Switch
- Securely mount the switch to the desired location using appropriate screws or mounting hardware.
Step 7: Power On
- Once the switch is securely installed, restore power to the circuit by turning it back on.
Frequently Asked Questions (FAQ)
-
Q: What type of conductors should I use for installation?
A: Use copper conductors only for proper electrical connection. -
Q: What is the recommended conductor size for this switch?
A: The recommended conductor size is 20A, 10AWG to 12AWG. -
Q: Can I install this switch myself?
A: Installation should be performed by a qualified person in accordance with national and local electrical codes to ensure safety and proper functionality.
4-Way Switch Diagram
Switch Instructions
- NOTICE : For installation by a qualified person in accordance with national and local electrical codes.
- WARNING : Risk of Electric Shock or Death. Disconnect power before installing.
- CAUTION : USE COPPER CONDUCTORS ONLY; 20A, 10AWG to 12AWG.
Remove insulation from conductors 1/2 inch.
Side Wire: Wrap the conductor securely around the terminal screw. Tighten
terminal screws securely, 14 pound·inch(1.6 N·m) of torque.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>