PEKTACO SSPF-V01 Stainless Steel Pet Water Fountain User Manual
- June 14, 2024
- PEKTACO
Table of Contents
STAINLESS STEEL
PET WATER FOUNTAIN
User Manual
SSPF-V01 Stainless Steel Pet Water Fountain
*Please read this manual before use
WARRANTY AND SUPPORT
This product has a warranty period of 1 year. If you have any questions,
please attach your order number and email the 24-hour online service:
[email protected]
The full details of the warranty and its terms applicable to this product can
be found in: ****www.pektaco.com
Or scan the QR code
IMPORTANT SAFETY INSTRUCTION
Before We Start: Care Instructions
In order to provide our pet with fresh and clean water continually, please
read and remember these three simple tasks:
Refill often| Please keep the water level above 50% or full all the time. The
pump is designed to work in water at least one inch deep. If the pump dries
without water, it may cause malfunction.
---|---
Clean the Pump and Fountain| Clean the pump and fountain separately using soap
and clean water every 4 weeks. Take care not to get soap in the filter, as it
cannot be rinsed out.
Replace Filters on a Regular Basis| Replace the filter case every 4 weeks when
you clean your fountain, and replace the foam filter every 4 weeks.
PRODUCT INTRODUCTION
- Product Diagram
- please confirm before installing
2. Product Accessories
PRODUCT SETTING STEPS
-
Before using
Step 1: Install pump holder first
Step 2: Place the pump into holder
Step 3: Place the sponge around the pump
Step 4: Soak the filter for 5 minutes
Step 5: Put the filter in the filter case and close it
-
Place the installed top cover back to the water tank NOTE: Carefully put the cover back to form the seal.
-
Insert the water faucet
-
Filled with water then connect with power
MAINTENANCE AND CLEANING
- Cleaning the water pump and water fountain regularly can extend their service life. It is recommended to clean them every 2 weeks and replace the filter element once every 2 weeks to prevent dirt from clogging the waterway. Clogged waterways can cause poor water flow, reduced water quality, noise, and other abnormalities.
- The specific steps are shown in the figure below:
– Take off the pump cover and rotor.
– Use the brush to clean the parts with water.
Cautious
Please be sure to shut down and disconnect the power supply when the equipment
is not in use, for safety.
Always keep the product on a flat surface when the equipment is being used.
This product is intended for indoor use only.
Do not allow this product to run without water.
Before maintaining or cleaning the machine, please disconnect the power
supply.
Place the fountain where your pet will use it. Fill the bowl with water,
leaving a half inch of space between the water and the rim. Make sure your
hands, the cord and the power adaptor are dry, then plug the fountain into an
outlet.
PEKTACO provides healthy and clear water, bringing flowing care and
happiness to your pet.
Scan the QR code for more details
[email protected]
****www.pektaco.com
| 
|
---|---|---
<https://qr.page/g/4Ps6c2ZVr6F>|
<https://qr.page/g/3Zegzhmufgd>|
<https://qr.page/g/MKA7vOglN1> 
|
---|---
<https://qr.page/g/1PxKI5VxNC8>|
<https://qr.page/g/2YClYPQSwFK> PEKTACO Cat Water Fountain
Manufacturer: Dongguan City ShuaiWei Technology Co., Ltd
Address: Room 402, Building 7, No.1, Tamilian Technology Park,
Chang’an Town, Dongguan City
MADE IN CHINA
Documents / Resources
|
PEKTACO SSPF-V01 Stainless Steel Pet Water
Fountain
[pdf] User Manual
SSPF-V01 Stainless Steel Pet Water Fountain, SSPF-V01, Stainless Steel Pet
Water Fountain, Steel Pet Water Fountain, Pet Water Fountain, Water Fountain,
Fountain
---|---