PEKTACO SSPF-V02 Cat Water Fountain User Manual
- August 17, 2024
- PEKTACO
Table of Contents
PEKTACO SSPF-V02 Cat Water Fountain
WARRANTY AND SUPPORT
This product has a warranty period of 1 year. If you have any questions, please attach your order number and email the 24-hour online service: support@pektaco.com
The full details of the warranty and its terms applicable to this product can be found in: www.pektaco.com
Or scan the QR code
IMPORTANT SAFETY INSTRUCTION
Before We Start: Care Instructions
In order to provide our pet with fresh and clean water continually, please read and remember these three simple tasks:
Refillohen| Please keep the water level above 50% or full all the time. The pump is designed to work in water at least one inch deep. If the pump dries without water, it may
cause malfunction.
---|---
Clean the Pump and Fountain| Clean the pump and fountain separately
using soap and clean water every 4 weeks. Take care not to get soap in the
filter, as it cannot be rinsed out.
Replace Filters on a Regular Basis| Replace the filter
case every 4 weeks when you clean your fountain, and replace the foam filter
every 4 weeks.
PRODUCT INTRODUCTION
Product Diagram
please confirm before installing
Product Accessories
PRODUCT SETTING STEPS
Before using
-
Step 1: Install the pump holder first
-
Step 2: Place the pump into the holder
-
Step 3: Place the sponge around the pump Step 4: Soak the filter for 5 minutes
-
Step 5: Put the filter in the filter case and close it
-
Place the installed back to the water tank
NOTE: Carefully put the cover back to form the seal. -
Insert the water faucet
-
Filled with water and then connected with the power
MAINTENANCE AND CLEANING
- Cleaning the water pump and water fountain regularly can extend their service life. It is recommended to clean them every 2 weeks and replace the filter element once every 2 weeks to prevent dirt from clogging the waterway. Clogged waterways can cause poor water flow, reduced water quality, noise, and other abnormalities.
- The specific steps are shown in the figure below:
- Take off the pump cover and rotor.
- Use the brush to clean the parts with water.
Cautious
-
Please be sure to shut down and disconnect the power supply when the equipment is not in use, for safety. Always keep the product on a flat surface when the equipment is being used.
-
This product is intended for indoor use only.
-
Do not allow this product to run without water.
-
Before maintaining or cleaning the machine, please disconnect the power supply.
-
Place the fountain where your pet will use it.
-
Fill the bowl with water, leaving a half inch of space between the water and the rim.
-
Make sure your hands, the cord, and the power adaptor are dry, then plug the fountain into an outlet.
-
PEKTACO provides healthy and clear water, bringing flowing care and happiness to your pet.
SPECIFICATIONS
| Model | SSPF-V02 |
|---|---|
| Power Adapter | Input Voltage 110-240 V 50-60Hz Output Voltage 5V |
| Pump | Ultra low noise AC Pump |
| Power Consumption | **** |
1.5W
Dimensions| 22•22.2•13cm
Weight| 0.8Kg
Material| Stainless Steel
Filter system| Activated Carbon & Ion Exchange Resin
Capacity| 3.2U108oz
FREQUENTLY ASKED QUESTIONS
What is the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain is a pet water dispenser designed for house cats, small animals, and dogs. It features a pump-driven system and provides a continuous flow of fresh water.
What is the capacity of the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain has a capacity of 3.2 liters (108 ounces), making it suitable for multiple pets or for those who prefer fewer refills.
What are the dimensions of the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain measures 8.6 x 8.5 x 4.5 inches, which allows it to fit comfortably in various locations around your home.
How much does the PEKTACO SSPF-V02 Cat Water Fountain weigh?
The PEKTACO SSPF-V02 Cat Water Fountain weighs 1.8 pounds, making it relatively light and easy to handle.
What type of pump does the PEKTACO SSPF-V02 Cat Water Fountain use?
The PEKTACO SSPF-V02 Cat Water Fountain uses a wired pump, which ensures reliable operation and consistent water flow.
What is the power source for the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain is powered via a plug-in power source, eliminating the need for batteries and ensuring a steady operation.
What is the warranty period for the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain comes with a 1-year warranty, providing coverage against manufacturing defects.
How do I clean the PEKTACO SSPF-V02 Cat Water Fountain?
To clean the PEKTACO SSPF-V02 Cat Water Fountain, disassemble the parts, wash them with warm soapy water, and rinse thoroughly. Regular cleaning is recommended to maintain hygiene and performance.
What is the price of the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain is priced at $26.62, offering an affordable option for providing fresh water to your pets.
What material is the PEKTACO SSPF-V02 Cat Water Fountain made from?
The PEKTACO SSPF-V02 Cat Water Fountain is made from durable plastic, ensuring longevity and ease of maintenance.
How does the water flow in the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain features a continuous flow of water, which helps to keep it fresh and encourages pets to drink more.
What are the benefits of using the PEKTACO SSPF-V02 Cat Water Fountain?
The PEKTACO SSPF-V02 Cat Water Fountain provides a continuous supply of fresh water, promotes hydration, and reduces the need for frequent refills, making it convenient for pet owners.
What should I do if the PEKTACO SSPF-V02 Cat Water Fountain is not turning on?
Check that the power adapter is properly connected to both the fountain and the wall outlet. Make sure the outlet is functioning by testing it with another device. Ensure that the fountain's power button is turned on.
Why is the PEKTACO SSPF-V02 Cat Water Fountain making an unusual noise?
An unusual noise may indicate that the pump needs cleaning. Turn off and unplug the fountain, then disassemble the pump and clean it according to the manufacturer's instructions. Check for any air bubbles in the water, which can cause noise.
How can I fix low water flow in the PEKTACO SSPF-V02 Cat Water Fountain?
Check if the water level is sufficient; the fountain needs enough water to maintain proper flow. Ensure that the pump is clean and free of debris. Also, make sure the filter is properly installed and not clogged.
VIDEO – PRODUCT OVERVIEW
DOWNLOAD THE PDF LINK: PEKTACO SSPF-V02 Cat Water Fountain User Manual