TOURATECH Yamaha Tenere 700 Engine Crash Bar Instruction Manual
- June 4, 2024
- Touratech
Table of Contents
TOURATECH Yamaha Tenere 700 Engine Crash Bar
We recommend having the accessory parts fitted by a specialist workshop.
-
Attention
-
Nota
-
Warning
-
Liquid
-
Couple
-
Template
-
2 Persons
-
M 4 2,7 0,8 Nm
-
M 5 5,5 1,7 Nm
-
M 6 9,7 3,0 Nm
-
M 8 23,0 7,9 Nm
-
MlO Nm 47,0 14,0
-
M12 80,0 24,0 Nm
-
M14 130,0 -,- Nm
-
M16 196,0 59,0 Nm
-
M18 270,0 -,- Nm
-
M20 385,0 114,0 Nm
Original motorcycle part
These instructions are written based on our current state of knowledge.
Information is provided without any guarantee as to its accuracy. Subject to
technical modifications. The order of assembly steps must be followed.
Touratech accepts no liability for incorrectly fitted parts and resulting
material damage or personal injury! Please observe applicable road vehicle
(construction and use) regulations as well as EC/ECE Directives and applicable
laws in your country. If parts are fitted which require inspection and/or
approval after fitting, take your vehicle to a testing station immediately and
have the vehicle papers updated. Check and if necessary tighten all bolted
connections after 50 km. Standard tightening torques in Nm for bolted
connections with strength class 8.8. For special tightening torques refer to
your specialist workshop! Please take into account that fitting panniers,
crash bars, foot peg lowering kits (rider and pillion),Kickstand
enlargmentplate, front spoilers and engine guards may restrict the bike’s lean
angle! If modifications are made to the fairing, stem, handlebar, fairing
parts, etc., ensure that electrical wiring, brake lines, accelerator and
clutch cables are refitted correctly. Check clearance, both sides with full
steering lock.
Always disconnect the battery when working on the electrics! We recommend
cutting protective film to size and applying it to impact areas that are
likely to be chipped by stones. Work on the brake system and suspension should
always be carried out by a specialist workshop. The maximum load on luggage
racks is 5 kg! Luggage racks Zega Pro TC is 10 kg! If other original
accessories or aftermarket accessories are used, ensure clearance, fitment and
do not come into contact with other parts! Apply conventional lubricant to
stainless steel bolts prior to assembly. PDF fitting instructions also can be
downloaded from the Touratech webshop.
Mounting instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>