GOTRAX ZY02-P Saddle Basic Scooter Seat User Manual
- June 14, 2024
- GoTrax
Table of Contents
GOTRAX ZY02-P Saddle Basic Scooter Seat
Welcome to use!
The scooter seat is available for electric scooters with a deck width of 145 mm and a height of 30 mm. Adaptable to GOTRAX models: GXL V2, Xr Ultra, RIVAL Please use as required. The scooter with seat can meet your seated riding needs, allowing you to enjoy a comfortable riding experience.
Products and Accessories
-
Seat post
-
Saddle Set
-
Base
-
Wrench
-
Accessories
-
(Screw x 4, Flat Pad x 4)
-
Plastic Locking Block x 2
-
Plastic Tube x 1
Schematic Diagram
- Seat Post Quick Release: Quickly open or lock the seat post for removal and installation.
Installation and Use
-
Place the base and tighten the screws Place the base on the back of the scooter and place two plastic locking blocks between both sides of the bottom plates and the scooter(as the picture shown). Install the hexagonal screws into the base mounting holes one by one and pre-tighten them, 8 turns per screw to fix the plastic locking blocks. Then tighten the screws in the order shown, one turn at a time, until they are locked in place.
-
Fit the plastic tube and the seat post quick release Make sure the plastic tube in the seat post and fit the seat post quick release with the restriction holes facing upwards.
-
Install the seat post and saddle set Open and loosen the seat post quick release, insert the seat post to the bottom, and lock the quick release. Then, fix the saddle set to the seat post and lock the hex nut on the turner with an outer hexagonal wrench.
-
Adjust the saddle set The seat can be adjusted by loosening the nut on the turner. Before riding, please check whether the seat is securely mounted. If not, use the outer hexagonal wrench to lock the hexagonal nut on the turne.
-
Seated riding After 4 steps of seat installation, please check the mounting is secure (mainly quick release and base screws are locked). After that you can start your comfortable riding experience in the seated position.
-
Scooter folding and opening When you need to fold the scooter, please loosen the quick seat post, take out the seat post and saddle set, and remove the safety latch.
Precautions
- Before each ride, please pay attention to check whether the seat is stable and that the quick release and four screws are locked.
- Before folding the scooter, please take out the seat post and saddle set first, and remove the safety latch .
- Please do not ride the scooter with more than one person or with other people.
product information
| Project | Scooter Saddle |
|---|---|
| Model | Saddle Basic |
| Packing Size | 530x135x230 mm |
| Materials | Steel, Aluminum |
| Cushion’s Materials | Elastic Sponge |
| Cushion workmanship | Vacuum Plastic-Absorbing |
| Max Loading | 264Ibs |
| Tools | Screwsx4, Flat Padx4, Plastic locking blockx2, Bushx1, 5mm Hex |
wrench x 1, 13&15 Open wrench x 1
Troubleshooting
We frequently update our manuals at GOTRAX. com, and reserve the rights to update and change manuals online.
Please contact our customer service team if you are experiencing problems or need more detailed information. They can be reached gotraxcanada.com
Warranty
For warranty information, please visit GOTRAX.com.
