DEWALT 30W Cordless Soldering Iron Kit User Manual
- June 14, 2024
- Dewalt
Table of Contents
Hot Glue Gun
User Manual
Safety Precautions
To use the hot glue gun properly and prevent any possible incidents, lease read and follow all precautions carefully.
- Keep out of children. This product should not be used by children except under adult supervision.
- Do not operate the device with wet hands. Do not immerse it into water or any other liquids.
- Do not disassemble the glue gun while using it. Please contact customer service for help.
- Switch off and pull out the battery when not in use. Do not recycle the used or melted glue stick. Do not pull out the remaining glue stick during or after using the device.
- The nozzle can heat up to 392°F during operation. Do not touch the nozzle with your hand.
Instructions:
- Before using the hot glue gun, please double check:
-the glue gun is in good condition,
-the nozzle and the glue stick are nice and clean. - Operation Steps:
1. Insert the glue stick into the glue stick hold port.
2. Plug your battery pack into the glue gun for powering.
3. Switch on, the power indicator will illuminate.
4. Preheat the glue gun for 3 to 5 minutes.
5. Pull the trigger to release the melted glue. The glue solidify in 30 seconds.
6. After using the glue gun, keep it from other stuff for 5 minutes until the melted glue dry and cool down.
Note:
- When the glue stick become shorter, please insert a new glue stick to push the remaining one for further use.
- Do not preheat the glue gun more than 15 minutes to avoid overheating.
Troubleshooting:
| Problem Description | Solution |
|---|---|
| No glue came out from) | |
| the nozzle | – The glue gun is not being preheated. |
– The battery is not plugged into the glue gun properly.
– The Battery docsn’t work
IThe glue gun is heating
– There is chance that there is a blockage inside the nozzle, please use a
needle to clean the clogged area.
– The glue will not automatically move forward to be melted
Please insert a new glue stick to push the remaining stick.
.
Ba;k-flow issue| – If therc is a back-tlow issue, the nozzle and the glue
residuc nced to be clean. Stop using the glue gun immediately. Twist| and
pull out the glue stick slowly after it cool down, clear out| the clogged
area of the nozzle.
– How to prevent
Keep the gluc sticks clean to avoid impurity or blockage in the nozzle.
How to use the glue properly| – Controlling the trigger
The harder you pressed the trigger, the more the glue stick will be melted and
released.. Press the trigger gently during operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>