Hinyx DT-680 2 In 1 Magsafe Wireless Charger User Manual
- June 14, 2024
- Hinyx
Table of Contents
Hinyx DT-680 2 In 1 Magsafe Wireless Charger
Product Specification
- Model NO : DT-680
SPECIFICATIONS:
- Output : 15W Max+3W
- Input : 5V/3A, 9V/2A
- Built-in Cable Interlace : Type C
- Dimension : 75.2×75.2×15.3mm
- Charging Distance : < 4mm
- Material : PC+ ABS + Aluminium Alloy+ Silicone
Product Show
Package Contents
- 1 pc x Wireless Charger
- 1 pc x User Manual
- 1pc Adapter
How to Work
Plug a power adapter to a wall outlet, and connect the type-c cable to the
power adapter , then place your phone or Apple Watch on the charging plate to
start charging.
Place your iPhone & Apple Watch on the charger.
Check the charging icon displayed on the mobile phone’s screen and Apple
Watch’s screen for the charging status.
FEATURE
- 15W max fast charging for Qi-enabled smart phones.
- MagSafe fast charging for iPhone 15/14/13/12 series.
- iPhone 7.5W fully compatible.
- 3W for Apple Watch Series 1-9/Ultra/Ultra 2/SE.
Charging modes for reference but no limited as below.
Charging Cautions.
Product specific safety information
- Place the device on flat surface
- Keep the device dry.
- Do not attempt to open the de?ce.
- Do not place bank cards near the device.
FCC Caution
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions
- This device may not cause harmful interference,
- This device must accept any interference received, inducing interference that may cause undesired operation.
Enjoy Your Wireless Charging!
Made in China
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>