soliseed 717H1hlofAL 4 Inch LED Can Lights Installation Guide
- June 14, 2024
- soliseed
Table of Contents
soliseed 717H1hlofAL 4 Inch LED Can Lights
INSTALL GUIDE
-
Turn power off
-
Remove previous fixture or bulb
-
Extend lamp at maximum height
-
Screw in the E26 adaptor into the open socket
-
Push the trim until flush with ceiling
In case the lamp trim cannot flush with the ceiling completely due to soft housing holder -
Retract a little bit according to the outstanding length. e. g. the length is 0.39″ then retract height 0.39″
-
Rotate the trim to screw in the E26 adaptor into the socket until tight
-
Turn power on and test
“‘The socket extender is a backup, not necessary to use it unless your housing is too deep that lamp base cannot reach socket.
WARNING
- Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>