HiQuick 24 x AAA High Quick and Performance User Manual
- June 14, 2024
- HiQuick
Table of Contents
High Quick & Performance
24 x AAA High Quick and Performance
User Manual
Thanks for purchasing HiQuick’s products!
For your own safety, please read this user manual carefully before using it
Specifications
Input: Micro USB/Type-C DC5V/2A Min
Output: AA: DC 1.2V 1800mA; AAA: DC 1.2V 900mA
Full-oad Voltage: 10W
Battery Charging Rate: 280%
Charging Way: Constant voltage and current control
Features
- Independent slot charger, our charger can charge 1/2/3…7/8 of AAJAAANi-MH and Ni-Cd rechargeabie batteries. These two types of batteries can be charged at the same time.
- Fast charging: DC5V 2A fast charging input port, compatible with AM/AAA Ni-MH and Ni-CD rechargeable battery, saving the long waiting time for charging.
- With advanced MCU control system, inteligent -V and -~V cuteoff charging tech, the charger tums to trickle charging automatically to prevent the batteries from over-voltage, over-current and over-heat.
- Broken & alkaline batteries detection. The smart charger could identiy batteries which are non-rechargeable, short-circuited or defective and switch off automatically to ensure safety.
- Low-voltage battery can be activated: even if the battery. Voltage is lower than 0.8V, the charger can activate and refresh .
Working Environment Con
Working Altude: Below 2000M
Storage Temperature: -10C-50C_Storage Hurmidity: 45% – 85%
Working Temperature: on 0 C- 35 C Working Humidity: 36% – 85% Surface
Temperature in Charging: ‘Surface Temperature of Charger: 35 C-60C
‘Surface Temperature of Battery: 25 C – 60C
Size & Weight
Size: (127 79.5 26.7) + 3mm Weight: 101g + 5g (No batteries included)
How to Use
Micro USB cable or Type-C cable plug in and power on: The LCD screen willlight
up for 0.5 sec, then go out.
Put rechargeable batteries in, the LCD will show:
“CHG” | Ladevorgang |
---|---|
“FULL” | Voll aufgeladen |
“ERR” | lnkompatibler Batterien |
Tips: DO NOT use the Micro USE Input and Type-C Input at the. same time.
Batterie Kapazitat
<1/3 blinken
“CHG” Ieuchtet auf| 1/3 blinken
“CHG” Ieuchtet auf| 2/3 blinken
“CHG” Ieuchtet auf| *ull blinken
“CHG” Ieuchtet auf
Notices
- Please use the micro USB cable provided by HiQuick
- Please connect 5V 2A adapter before installing batteries.
- Install batteries into the charger correctly by making sure the +/- pole of battery matches the +- pole of the charger.
- The charger can charge each battery independently
- The charger must be used at an operating temperature of 0-35 C
- The absolute 0 Volt battery can not be charged with this charger.
- The charger is ONLY designed for ANAAA Ni-H and Ni-Cd rechargeable batteries,
- New battery will reach its best performance after 3-5 times of charge-discharge cycles.
- Battery power will lose because of long-time storage, please charge the battery fully before using it again.
- Please cut off the power supply after the batteries are fully charged.
- Its normal that the battery becomes hot while charging. It will ool down to normal degree later, please feel free to use it
Important Safety Instructions
- Tum off the charger and take the batieries out after charging is completed.
- D0 NOT disassemble and reassemble the charger, or it may cause shortcircul.
- D0 NOT charge batteres whose cover are damaged, or it may Gause short ircul and a fre hazard
- D0 NOT charge non-rechargeabie battries or ther ypes of bateries. It may cause batery leakage, battery explosion. personal injuries, and etc.
- D0 NOT put anything on the charger while charging batteris, will accumuiate heat and then cause a fr hazard.
- DO NOT instal the battery inversely o t may cause short circut or a fr hazard.
- Indoor uss only, keep it away from direct sunlight or moistihigh-temperature environmont
- Chicren should use this charger under aduls supervsion.
- Place this charger out of each of hicren.
Warranty
We provide 30 days worry-free money back and one year limited warranty.
Any problem, please feel free to contact us.