HiQuick HQ-6715 9V Battery Charger with LCD Screen User Manual

Table of Contents

Independent slot charger, our charger can charge four 9V rechargeable batteries. The batteries can be charged at the same time.
Fast charging: DC5V 2.0A fast charging input port, compatible with 9V rechargeable battery, saving the long waiting time for charging.
With an advanced MCU control system, and intelligent V and – V cut-off charging tech, the charger turns to trickle charging automatically to prevent the batteries from over-voltage, over-current and over-heat.
Identify automatically: identify non-rechargeable batteries, short-circuit batteries and deficient rechargeable batteries through the microcomputer IC, and will not charge these batteries to ensure safety.
Low-voltage battery can be activated: even if the battery voltage is lower than 0.9V, the charger can activate and refresh it.

Working Environment Condition

Surface Temperature in Charging:

Plug in the Micro USB cable or Type-C cable and turn on the power: the backlight of the LCD screen will light up to show all characters. If there is no battery in the battery slot, the backlight will automatically go out after 5S. Put recharaeable batteries in. The LCD will show:
Tips: Only for charging 9V rechargeable batteries, and it may burst or leak if charging for another type of battery or equipment.

Notices

Please use the micro USB cable provided by HiQuick.
Please connect the 5V 2A adapter before installing the batteries.
Install batteries into the charger correctly by making sure the +/- pole of the battery matches the +/- pole of the charger.
The charger can charge each battery independently.
The charger must be used at an operating temperature of 0-35 °C.
The absolute 0 Volt battery can not be charged with this charger.
The charger is ONLY designed for 9V rechargeable batteries.
The new battery will reach its best performance after 3-5 times of charge-discharge cycles.
Battery power will be lost because of long-time storage, please charge the battery fully before using it again.
Please cut off the power supply after the batteries are fully charged.
Normally, the battery becomes hot while charging. It will cool down to normal later, please feel free to use it.

Turn off the charger and take the batteries out after charging is completed.
DO NOT disassemble and reassemble the charger, or it may cause a short circuit.
DO NOT charge batteries whose cover are damaged, or it may cause a short circuit and a fire hazard.
DO NOT charge non-rechargeable batteries or other types of batteries. It may cause battery leakage, battery explosion, personal injuries, etc.
DO NOT put anything on the charger while charging batteries, it will accumulate heat and then cause a fire hazard.
DO NOT install the battery inversely, or it may cause a short circuit or a fire hazard.
Indoor use only, keep it away from direct sunlight or noise/high-temperature environment.
Children should use this charger under adult supervision.
Place this charger out of reach of children.