HiQuick HQ-6928 LCD Battery Charger User Manual
- June 15, 2024
- HiQuick
Table of Contents
HiQuick HQ-6928 LCD Battery Charger
User Manual
- Thanks for purchasing HiQuick’s products!
- For your safety, please read this user manual carefully before using it.
Overview
Specifications
- Input: Micro USB/Type-C DC5V/2A Min
- Output: AA: DC 1.2V 1200mA;
- AAA: DC 1.2V 600mA
- Full-load Power: low
- Battery Charging Rate: 285%
- Charging Way: Constant voltage and current control
Features
- Independent slot charger, our charger can charge 1/2/3…10/11/12 of AA/AAA Ni-MH and Ni-Cd rechargeable batteries. These two types of batteries can be charged at the same time.
- Fast charging: DC5V 2A fast charging input port, compatible with AA/AAA Ni-MH and Ni-CD rechargeable battery, saving the long waiting time for charging.
- With an advanced MCIJ control system, and intelligent V and – V cut-off charging tech, the charger turns to trickle charging automatically to prevent the batteries from over-voltage, over-current and over-heat.
- Identify automatically: identify non-rechargeable batteries, short-circuit batteries and deficient rechargeable batteries through the microcomputer IC, and will not charge these batteries to ensure safety.
- Low-voltage battery can be activated: even if the battery voltage is lower than 0.9V, the charger can activate and refresh it.
Working Environment Condition
- Working Altitude: Below 2000M
- Storage Temperature: -10 C -50 c
- Storage Humidity: 45% – 85%
- Working Temperature: 0 C- 35 C
- Working Humidity: 35% – 85%
- Surface Temperature in Charging:
- Surface Temperature of Charger: 35 C -60 c
- Surface Temperature of Battery: 25 C- 60 C
How to Use
- Plug in the Micro USB cable or Type-C cable and turn on the power: the backlight of the LCD screen will light up to show all characters.lf there is no battery in the battery slot, the backlight will automatically go out after 5S.
- Put rechargeable batteries in, the LCD will show the following situations:
Notices
- Please use the micro USB cable provided by HiQuick.
- Please connect the 5V 2A adapter before installing the batteries.
- Install batteries into the charger correctly by making sure the +/-pole of the battery matches the +/- pole of the charger.
- The charger can charge each battery independently.
- The charger must be used at an operating temperature of 0-35 C.
- The absolute 0 Volt battery can not be charged with this charger.
- The charger is ONLY designed for AA/AAA Ni-MH and Ni-Cd rechargeable batteries.
- The new battery will reach its best performance after 3-5 times of charge-discharge cycles.
- Battery power will be lost because of long-time storage, please charge the battery fully before using it again.
- Please cut off the power supply after the batteries are fully charged.
- Normally, the battery becomes hot while charging. It will cool down to normal later, please feel free to use it.
Important Safety Instructions
- Turn off the charger and take the batteries out after charging is completed.
- DO NOT disassemble and reassemble the charger, or it may cause a short circuit.
- DO NOT charge batteries whose cover are damaged, or it may cause a short circuit and a fire hazard.
- DO NOT charge non-rechargeable batteries or other types of batteries. It may cause battery leakage, battery explosion, personal injuries, etc.
- DO NOT put anything on the charger while charging batteries, it will accumulate heat and then cause a fire hazard.
- DO NOT install the battery inversely, or it may cause a short circuit or a fire hazard.
- Indoor use only, keep it away from direct sunlight or moist/high-temperature environments.
- Children should use this charger under adult supervision.
- Place this charger out of reach of children.
Size & Weight
- Size: (18779.5 26.7) ±3mm
- Weight: 155g ± 5g (No batteries included)
- Size: ± 0.12inch
- Weight: 0.221b(No batteries included)
Warranty
- We provide a 30-day worry-free money-back back and a one-year limited warranty.
- Any problems, please feel free to contact us.
Read User Manual Online (PDF format)
Loading......