GoveeLife H5043 Water Leak Detectors User Manual

GoveeLife H5043 Water Leak Detectors User Manual

Model; H5043+H5058
Water Leak Detector 2 with Wi-Fi Smart Gateway 2

Detectors have paired with the gateway in advance. You only need to connect the gateway to the network.

At a Glance

Water Leak Detector is a device that sounds an alarm once detecting water drip or leak. Connecting to Wi-Fi via the gateway, it instantly sends you alert notifications of water leaking by app or email whether you are at home or outside.

Wi-Fi Gateway
Wi-Fi Pairing Button: Connect the gateway to Wi-Fi, LED Indicator: Show status of the gateway.

Water Leak Detector
Sensor Contact: Detect water drip. Sensor Probe: Detect water leak.
Push Button: Pause alarm I Adjust volume. Batteries: 2 X AAA Battery.

Packing List

Checking the Water Leak Detector

Installing Your Device

1. Plug the gateway into a power outlet;
2. Lay the water leak detector flat.
   Notice: Keep distance between the gateway and the detector less than 400m/ 1 300ft.

Preparation Before Connecting

1. A WI-Fl router supporting the 2.4GHz (NOT 5GHz) and 802.11 b/g/n bands.
   (Notice: Most of SGHz routers can also be set to 2.4GHz band or dual band.)

2. Make sure WI-A name and password are correct.

3. A smartphone or tablet supporting 2.4GHz network.

Connecting to a Wi-Fi Network

Please check the above steps and try again; or you can select “H5043” in the app and tap “Video Guide” for more instructions.

Notification Setting

App notification: Open app, select “water leak detector’ In the device list. and tap setting icon in the top right corner.

Add or Re-add Water Leak Detector
Notice: The detector is added by default when the gateway connects to WI-Fl successfully.

Notice:
If the gateway fails to pair to the detector in 60s, its indicator will flash blue quickly and it will exit the pairing mode.
There’s Is delay for beep sound after you press the Push Button.

Please check the above steps and try again if pairing fails.

Troubleshooting

1. The gateway cannot connect to Wi-Fi. / The connection is unstable.

a. 5GHz network is not supported. The device only supports 2.4GHz.

b. Check the name of the network and password.
c. Place the gateway within coverage of the router signal.
d. No obstructions like metal door or wall between the gateway and the detector are suggested.

2. The water leak detector cannot work.
a. Pull out the Insulation sheet before using.
b. Open the back cover via a PHOO/PHO screwdriver, remove and re-install the battery.
c. Check whether the battery is running low.

3. No/Delayed notification in the app.
a. Make sure that Android dl!Ytce users turn on Location and IOS users select “Setting – Govee Home – Location -Always’ in the phone.
b. Keep the distance between the gateway and the detector as close as possible.
c. No obstructions between the gateway and the detector is suggested.
d. The time Interval between two water detection should be longer than 1 hour, otherwise the app won’t push notification.
e. Check whether the Indicator of the gateway flashes when the detector Is triggered. If not. please re-add the detector.

Warning

• Keep devices work temperature within 32•F • 140’F and humidity below 90’l6RH.
• Do not disassemble devices violently.

Specifications

Customer Service

FCC and ISED Canada Statement

This device complies with Part 1 s of the FCC Rules and Industry Canada llcence-exempt RSS standard(s). Operation Is subject to the following two conditions:

(1 )This device may not cause harmful Interference, and (2) This device must accept any interference received, including Interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the Instructions, may cause harmful Interference to radio communications. However, there is no guarantee that Interference will not occur In a particular installation.

If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user Is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

FCC and IC Radiation Exposure Statement

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be Installed and operated with minimum distance 20cm between the radiator & your body.

Re1pon1lbl11 party:
Name: GOVEE MOMENTS(US) TRADING LIMITED
Address: 2501 Chatham Rd Suite R Springfield IL 62704
Emall: support@govee.com
Contact information:
https:ttwww.govee.com /support

The trademark GoveeUfe has been authorised to Shenzhen
Qianyan Technology LID.
Copyright Cl2021 Shenzhen Qlanyan Technology LTD. All Rights Reserved.

The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Shenzhen Qianyan Technology LTD is under license.

For FAQs and more information, please visit: www.govee.com

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>