KIMILAR Fitbit Sense 2 Pack Screen Protector Compatible User Guide
- June 14, 2024
- KIMILAR
Table of Contents
KIMILAR Fitbit Sense 2 Pack Screen Protector Compatible
Product Information
The product is a charging dock for Fitbit smartwatches. It is compatible with the following Fitbit models: Fitbit Versa 4, Fitbit Sense 2, Fitbit Versa 3, and Fitbit Sense. The input voltage required for charging is DC5V with a current of 0.5A. The output voltage provided by the charging dock is DC5V with a current of 0.45A. The product has four charging pins located on the back of the watch.
Product Usage Instructions
- Connect the power outlet to the charging dock using the provided cable.
- Ensure that the input voltage of the power outlet matches the required input voltage of DC5V.
- Place your Fitbit smartwatch on the charging dock, aligning the four charging pins on the back of the watch with the corresponding pins on the dock.
- Make sure the charging dock is connected to a power source. The charging process will begin automatically.
- Monitor your Fitbit smartwatch to ensure it is charging properly. If the watch prompts slowly charging, try the following solutions:
- Check if the charging pins on both the watch and the dock are clean and free from dust or debris. Clean them if necessary.
- Ensure that the power outlet is functioning correctly and providing sufficient power. Try using a different outlet or power source.
- Verify that the cable connecting the power outlet and the charging dock is securely plugged in on both ends.
- If none of the above solutions work, contact customer support for further assistance.
Please note that this product is made in China.
SPECIFICATION
- Input : DC5V / 0.5A
- Output : DC5V / 0.45 A
- Compatible Device
- Fitbit Versa 4
- Fitbit Sense 2
- Fitbit Versa 3
- Fitbit Sense
Precautions
- Please make sure the power outlet or USB interface you use is produced by a reliable manufacturer.
- Please make sure the charging metal terminal on the back of the watch is clean before charging, which will avoid poor contact during charging.
- Please make sure the watch is in good contact with the dock when placing the watch onto the dock. Avoiding poor contact caused by the watch strap or any other thing interfering with the contact between the watch and the dock.
- During the charging process, if the watch prompts ” slowly charging “, as shown in the right figure, please refer to the solution.
- Please don’t use the product in a humid, hot environment.
- Please don’t use organic solvents such as detergent to wipe the dock. Please clean it with a wet cloth and protect the charging pins away from water.
- It is strictly forbidden to dismantle the product and keep it close to the fire source.
- Children or pets should not be exposed to this product.
Solutions if the watch prompts “slowly charging”
- If the voltage of the power outlet is lower than 5V, it will trigger the internal slow charging alarm of the watch, and the watch will automatically enter the protection mode to charge. It is recommended to replace the 5V outlet of the regular manufacturer (the slow charging mode can still be fully charged, but the charging speed is reduced by 30%);
- If the contact on the back of the watch is dirty, it will lead to poor contact during charging. Therefore, it is necessary to clean the contact with a cotton swab by wiping it before charging;
- If the watch’s charging pins aren’t in full contact with the charging base, it will result in poor contact. Therefore, it is necessary to reposition the watch after removal.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>