HOLY STONE TY-T6 Drone for Adults User Guide
- June 14, 2024
- HOLY STONE
Table of Contents
HOLY STONE TY-T6 Drone for Adults
Unboxing and Setup Guide
- Follow the steps as below to connect and calibrate the controller with the drone.
- Please note that if the calibration is not complete, then the drone may fly in a tilted manner.
- If behaviours of being upside down or titled exist during landing, Then please turn off the drone and controller and then re-connect and re-calibrate it.
Installation Instructions
- Install the 4 protective guards under the motor seats as shown above.
- Insert 3*AA 1.5V batteries into the remote controller as shown above and then install the drone battery into the drone.
- Place the drone on the ground in the direction shown above.
- Put the drone horizontally while matching the frequency.
- Press and hold the button for 3 seconds to start. (The indicator will shine quickly after turning on).
- Click the remote control power button to turn it on. (You will hear a “beep” sound and see a flashing red light.).
- Push the left joystick up once.
- Push the left joystick down once. (At this point, the red light on the remote control and the drone will stay on, indicating that the remote control is connected to the drone.)
- Pull the left-right joystick diagonally down at a 45° angle at the same time(You will hear a “beep” sound for 2 seconds, indicating that the drone has been successfully calibrated)
Notice
- Once setup is completed, Push the left stick up once to activate the propellers, and push it again to take off. Please try to use the drone in a windless or light wind environment.
- If the remote control light flashes during flight, please replace the remote control batteries promptly.
- If you hear a continuous beeping sound from the remote controller during the flight, please replace the drone battery promptly.
- Given safe transportation, the factory battery charge is low. Please fully charge it before using it!
Propeller Replacement Instructions
- Please note the label (A or B) on the propeller when replacing it, and install it in the correct position as shown above.
- First, take out the propeller cap, use a screwdriver to loosen the screw and take out the propeller, and replace the propeller with the corresponding label, then tighten the screw and install the propeller cap.
Thank you for your trust and support of our store!
Documents / Resources
| HOLY
STONE TY-T6 Drone for
Adults
[pdf] User Guide
TY-T6, TY-T6 Drone for Adults, Drone for Adults, Adults
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>