ZSZ MS-001 Smart Locks for Front Door Instruction Manual
- June 14, 2024
- ZSZ
Table of Contents
Installation Manual
(MS-001)
MS-001 Smart Locks for Front Door
Part 1.Parts list
Part 2.Parts identification
Step 1.Check door dimensions
Step 2.Check door dimensions
Make sure the word “UP” is facing up Align latch slot with door hole
center How to adjust the length of the latch
Facing the side with the up sign, press your thumb against
the deadbolt to ensure that it does not extend.
Rotate it clockwise, then pull it out and rotate it counterclockwise until you
hear a snap
Step 3.Install exterior assembly
- Ensure deadbolt be in unlock position
- Ensure the emergency M-key works normally
Route the cable through the mounting platehole
Ensure the paddle is in the center of the hole
Test the paddle by rotating it to see if the latch can be extended and
retracted smoothly Fix the mounting plate with mounting screws (6 -1/ 6 -2 or
6 -3/ 6 -4)
Step 4.Install interior assembly
Fix
interior assembly with interior screws ( 9 -1 /9 -2 and 8 -1) Test the lock by
rotating the thumb turn to see if the bolt can be extended and retracted
smoothly Install the battery and put the battery cover on
Step 5. First startup
When the lock first startup, it will automatically adapt to the actual running direction through unlocking and locking actions
Step 6. Check after installation
Step 1-1: Enter default user code 123456 and unlock key to check user
code unlock function.
Step 1-2: Enter any fingerprint to check the fingerprint unlock function.
Step 2: Check auto lock function: wait 10 seconds, the lock will
automatically close.
Step 3: Check hand knob open the lock: rotate the hand knob to smoothly
open and close the lock.
Step 4: Check unlock/lock button: click the button to open and close the
lock normally.
Step 5: Check emergency M-key: use emergency M-key can open and close the
lock normally.
If all of these functions can be used normally, please use the Smart Lock
Product Manual to start setting up your lock!