Starline EL209 Solar Bluetooth Speaker User Manual

Starline EL209 Solar Bluetooth Speaker

Product Introduction

• The ES-T69 PRO MAX /EL209 is an outdoor portable solar Bluetooth speaker with high-power LED lighting and colorful lights, which can adapt to various outdoor environments that require lighting conditions; imported audio power amplifier, and Hi-Fi speaker, enable to enjoy high quality music in any condition.
• With the built-in high power monocrystalline silicon solar panel, the speaker can recharge and play music continuously outdoors. Half an hour solar charging can play music for 30 minutes at medium volume. When fully charged it enables up to 20 hours of continuous music playing time at low volume, and up to 10 hours in medium volume. (Note: the data is based on the field test and may vary under different conditions, such as different place, season, sunlight intensity, volume, and music type played etc.)
• This product is IP66 rated and is waterproof, drop-proof and dust-proof, making it possible to use under most of the outdoor conditions.

Specifications

| Project| Parameter
---|---|---

1

| Bluetooth Version| Bluetooth 5.1 (support TWS)

2

| Wireless transmission distance| 8~10m

3

| Audio Input| Bluetooth, AUX, TF card

4

| Audio Format| MP3, WAV, WMA

5

| Audio signal to noise ratio| ≥75dB

6

| Distortion| ≤0.1%

7

| Audio output power| 2*10W

8

| Speaker| Diameter 46mm, 20 cores, 4Ω 10W

9

| Frequency response| 20Hz – 20KHz

10

| Operating Voltage| 6.0 – 8.4V

11

| Standby current| ≤0.5mA

12

| Built-in battery| 3.7V/5000mAh

13

| Charging Specification| 5V/2A

14

| Solar Panel| 9V/1.2W

15

| Working temperature| 0℃-60℃

16

| Storage temperature| -20℃-45℃

Product overview

1. Solar charging indicator (Green)
2. LED lights switch
3. Previous song (short press)/volume- (long press)
4. Incoming call /play/pause (short press for play/pause, double click for call)
5. Microphone
6. Next song (short press) / volume+ (long press)
7. Power switch
8. Working indicator
9. Speaker
10. Solar panel
11. Lanyard hole
12. Colorful lights
13. AUX input
14. TYPE-C interface
15. TF card interface

Bluetooth Wireless Connection

1. Long press the power switch (7) for more than 2 seconds at Turn off mode to get into the wireless pairing mode, indicator (8) the blue light will flash alternately.
   (The product will shut down automatically if there is no device successfully paired in 15 minutes, or by short pressing the power switch (7)).

2. Searching the Bluetooth signal of nearby devices through your smart phone or any other devices and find the Product Name: ES-T69 PRO MAX.

3. Select to connect ES-T69 PRO MAX & if successful, the blue indicator (8) will keep on. Turn on the music player of the Bluetooth devices such as mobile phones to play music. The blue indicator (8) will keep blinking while data is being transferred.

4. TWS pairing
   4.1 Turn on the two ES-T69 PRO MAX speakers when Bluetooth is not connected, double-click the volume + button (6) to enter the TWS pairing function (ensure that the distance between the two products is close). When the TWS pairing is successful, the blue light of the host flashes slowly & the blue light of the slave is always on. After pairing and connecting with the mobile phone or other digital devices, you can enjoy the music then.
   4.2 After TWS is paired successfully and not connected to other digital devices, click the speaker phone button (4) to cancel the TWS pairing. The indicator (8) light in blue turns fast flashing, then they can be used as individual speaker.

AUX input to play music

When the ES-T69 PRO MAX is turned on and connected to an audio equipment such as a mobile phone with the
3.5mm AUX audio cable to the AUX input port (13), the sound of your audio equipment will then be amplified by this ES-T69 PRO MAX.
Note: In AUX input mode, Bluetooth is automatically turned off. After exiting AUX mode, Bluetooth will automatically connect back to a device paired before.

Insert the TF card to play music

Turn on the ES-T69 PRO MAX. In any state, insert a TF card with MP3, WMA, WAV format into the TF input (15), it automatically plays music.
(Note: under TF card mode, Bluetooth is automatically turned off. After the TF Card is turned off, Bluetooth will automatically connect back to a device paired before. ）

Song switching/volume adjustment/play/pause

1. Short press the next song / volume + (6) to switch to the next song; Short press the previous song / volume – (3) to switch to the previous song.
2. Long press next song / volume + (6) to increase the volume, when it reaches to the maximum, there is a “DoDo” sound. Long press the previous song / volume – (3) to decrease the volume.
3. Short press the call/ play / pause (4), play or pause music.
   Note: In AUX input mode, the song switching function is invalid.

Phone answering and dialing out

1. When the device is connected to the phone, short pressing the call/play/pause (4) to answer the incoming phone call. Mini microphone (5) is the receiver, speaking to it will get the best sound effects. Short pressing the call/play/pause (4) again to hang up the phone call.
2. After Bluetooth is connected, double-click the call/play/pause (4) button, to dial the previous call. Short press to pause or hang up.

Battery Indicator

When the product is in a low battery state, the product will automatically shut down after three low battery alarm prompts.

Adapter charging

Connect one side of the TYPE-C cable to the product DC charging input (14), the other side connects to 5V/2A adapter, the product begins to charge. The charge indicator turns red and will turn off when fully charged.

Solar panel charging

In any state, place the solar panel (10) in the direction of the strongest sunlight, the product will start charging automatically. The green light of the solar charging indicator (1) is on. When there is no sunlight, the solar charging indicator (1) turns off automatically, charging stops.

Colorful lights

1. Double-click the button (2) to switch the LED lighting.
   After the LED is turned on, click to switch the lighting effect. White lights are low, medium, high, flashing & SOS, followed by red, green, blue, purple, yellow, orange & ambient lights in 7 modes. Double-click to open the memory of the last lighting effect.

2. Press and hold the button (2) for 2 seconds to switch to the music mode. When playing music, there are 5 color light display modes: (1) full colors horse racing, (2) both sides flashing towards the center, (3) the center flashing to both sides, (4) extending from top to bottom, (5) level indication. Double-click the button to switch to the lighting mode, single-click to switch the music lighting effect, and long press to turn on the memory of the last music lighting effect.

Important safety information

1. Read and understand all safety guidelines.
2. Observe all warnings and guidance information marked on the product.
3. Use a charging device with output DC 5V/2A to avoid damage to the device.
4. Do not splash this product with any chemical liquid or immerse it in water for a long time. This product is IP66 waterproof rated. Need to remove all cable connections and close the protective cap to ensure the waterproof functionalities. Exposing this product to liquid without these measures may cause permanent damage to the speaker. Do not expose this product to water while it is charging, which will cause permanent damage to the speaker or power supply.
5. Do not expose this product to high temperature heat sources, do not bake or blow dry at high temperature.
6. Do not allow the product to fall from a high place or subject to heavy blows or heavy pressure.

Packaging item lists

1. ES-T69 PRO MAX Solar Bluetooth Speaker：1pc
2. Audio cable：1 pc
3. USB charging cable：1 pc
4. Strap：1 pc
5. Manual：1 pc

Troubleshooting

• Turn off automatically when turned on: the battery is low, please charge it before use.
• Automatic shutdown or restart of playback: insufficient battery power leads to low voltage and cannot be played, please charge it before use.
• No sound from the speaker: check if the volume is turned on; long press Next song (short press) / volume+(long press) (6) to increase the volume.
• The button has no function or function error: turn it off and turn it back on.
• Cannot connect with the Bluetooth function: 1) check if the Bluetooth function is turned on, 2) check if there is a Bluetooth device available, and 3) check if the Bluetooth device is enabled in a normal connection.

▲ Warning:

• DO NOT leave the product in any overheated environment. The overheating could damage the product or cause body injuries.
• Do NOT attempt to disassemble this product by non-professionals.
• Follow the local laws and regulations to dispose of this product with Lithium-ion battery.
• Do not touch the diaphragm on the side of the speaker with sharp objects and fingers, it will affect the sound effect and service life of this product.

Safety Instructions

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>